Caught in running equipment or machinery during regular operation · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at Archer Daniels Midland Company, 540 South Street, LINCOLN, NEBRASKA 68502
on — Cuts, lacerations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee lacerated the ring and middle fingers of the left hand while running the Hesser machine.
On April 27, 2025, employees were performing a railcar switch. When the train began to shift back, the injured employee's right arm got crushed between the knuckles of two railcars. The employee was hospitalized with fractures to their forearm.
On January 8, 2023, at approximately 2:20 AM, an employee was accessing a drag conveyor when his right hand contacted the running conveyor. He sustained amputation of his right index and middle fingers.
On August 7, 2022, at about 12:30 PM, an employee was working to open a gate at the bottom of a railcar when they were struck in the face with a metal prybar. This resulted in a laceration below the right eye, and an injury to the right eye that required surgery and hospitalization.
On August 30, 2021, an employee was opening the door to a pallet magazine while operating a forklift. As the employee backed up the forklift, the employee's fingers were pinched between its frame and the magazine door. The employee suffered a fingertip amputation.
An employee was on the ground by a railcar attempting to unplug an oil line to allow the oil to flow from the railcar to a tank in the facility. Oil splashed out of the top of the railcar and landed on the employee causing burns to the top of the employee's shoulders.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 311211)
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was checking a flour roll stand for a blockage. The employee's right hand was caught in an ingoing nip point on the machine, causing partial amputations to the thumb and middle, ring, and little fingers.
An employee was climbing an A-frame ladder to adjust an exhaust pipe on the wall to let the heat out. The employee fell 4-5 feet and injured his right tibia and ankle.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.