American Seafoods

An employee's fingertip was amputated while the employee attempted to straighten a box in a vertical box conveyer system.

An employee was fixing ceiling tiles while working from a ladder when they fell to the floor and sustained a hip fracture.

An employee was on an A-frame ladder retrieving materials from a shelf. He slipped and fell and his leg got caught in the ladder rungs, breaking his left tibia.

An employee was unloading materials from a flatbed trailer when they fell from the trailer and landed on the ground. The employee sustained a fractured left leg.

An employee was unloading appliances at a customer location for delivery. The employee was moving a water heater to be placed on the liftgate when he stepped backward and fell to the ground. The employee sustained rib and back injuries.

An employee was coming down a portable ladder when they slipped and fell to the ground, resulting in a right forearm fracture.

An employee was working on a fillet machine when it caught his right little finger, lacerating and breaking it.

An employee was cutting a fish hung up on a hook using a knife when the hook came off, causing his hand to slip. The employee's right thumb was severely lacerated by the knife.

An employee was clearing a jam in a fish skinning machine when his hand became caught between two plastic cogs that operate the conveyor belt. His hand was injured and required surgery. His left index finger was surgically amputated. The machine was energized at the time of the incident.

An employee was in a tunnel freezer, which was being turned on for the first time. The baffling for the evaporator fan got stuck in the siding. The employee ascended a 5'9"-tall cart to reach the raised baffling panel. The raised baffling shifted and dropped, trapping the employee's arm between the aluminum and foam core baffling. The employee sustained a severe laceration to the lower forearm/upper wrist and severed ligaments. The employee was hospitalized.

An employee was using tongs to grab shrimp when their finger got caught inside the tongs. The employee sustained an amputation to their fingertip.

An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.

An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.

An employee was testing and troubleshooting the gang cylinder valve located in the gang area of the sawmill. The employee's fingertip was amputated by the gang cylinder valve.

An employee was unlocking containers on deck. The employee was de-lashing while standing on the edge of the lid. The lashing bar he was holding came off the cone, causing him to turn 90 degrees and strike a railing behind him. The employee sustained four fractured ribs.

An employee parked a side-by-side on the fixed internal ramp aboard a cargo ship. They exited the side-by-side and went to inspect the cargo below. The side-by-side rolled toward the employee and struck them as they were walking toward the edge of the ramp. The employee was knocked off the ramp and landed on the lower deck approximately 8 feet below. The employee was hospitalized with a fractured shoulder.