NATIONAL PARK SERVICE

An employee was preparing to conduct maintenance on a riding lawn mower and lifted the mower deck upward to its vertical position with assistance from another employee. A third employee pulled a locking pin, causing the front wheel mount to move forward into the cab. The cab entrance hand hold crushed the little fingers on the injured employee's hands. The employee was hospitalized and required surgical amputation of the right little finger to the second joint, as well as debriding and stitches to the left little finger.

An employee was riding on a stand-up blower to clean leaves and other objects from sidewalks and roads. The blower hit a hole and then struck a tree. The employee's right little finger was crushed.

A ranger was performing back-country patrol duties while hiking. As they were climbing a technical rock patch, a rock handhold broke, causing the employee to fall approximately 15 feet before their belay engaged. The employee contacted a rock, resulting in a fracture to the right ilium as well as a subcutaneous hematoma to the right gluteal region.

An employee was walking near the elevator building when she slipped on ice and fell, hitting the back of her head on the pavement. The employee sustained a skull fracture, cerebral bleed, and temporarily lost consciousness.

An employee was leaving a building when she tripped and fell down a set of four or five stairs, striking her head on the concrete sidewalk below. She suffered a concussion and was hospitalized.

An employee was operating a sit-down type of material handling equipment (MHE). They were turning the MHE with the clamp attachment in the air when the MHE fell over onto its right side. The employee's right foot was caught under the battery cover of the MHE. The employee sustained a chemical burn from the battery and a fractured right ankle.

An employee was driving a snowmobile when it flipped over. The employee suffered a broken rib.

An employee was driving an unloaded forklift outside a building. During a left turn, the forklift drove off the paved area onto an unpaved surface, became unstable, and tipped over. The employee was pinned under the forklift and suffered two broken leg bones and a broken hip.

An employee was riding in a utility task vehicle when it overturned. The employee sustained a broken leg.

An employee was trimming tree branches from an aerial lift. As they were maneuvering the aerial bucket lift from inside, the truck drove over soft ground and tipped over. The bucket lift fell to the ground with the employee tied off inside, resulting in rib fractures.

After completing a fitness test, an employee experienced lower leg pain and an inability to walk. The employee was hospitalized for compartment syndrome in both legs.

An employee was cutting up a large tree that had blown down on a rocky ledge on a hill. He began cutting on the uphill side of the tree, but due to obstructions he had to move to the downhill side. The tree separated from its 7-foot root ball, which started sliding toward him. While attempting to get out of the way, he tripped and fell to the ground, striking his head on an unknown object. As the root ball continued to move toward the employee, he made it below the level of the rock ledge. The root ball rolled over when it reached the ledge and pinned the employee's lower leg, and broke his fibula. He also suffered scrapes and bruises from the fall.

An employee was walking on a trail in a national park and stepped onto an angled and flat slab of granite when her ankle rolled and her weight shifted, but she did not fall. She was hospitalized with a fractured tibia and fibula and a dislocated ankle.

An employee was offroad, looking for a lost hiker. The employee fell off a canyon rim edge and landed on rimrock 5 or 6 feet below, suffering a separated shoulder and a head injury that required stitches. The employee was hospitalized.

An employee was preparing to conduct maintenance on a riding lawn mower and lifted the mower deck upward to its vertical position with assistance from another employee. A third employee pulled a locking pin, causing the front wheel mount to move forward into the cab. The cab entrance hand hold crushed the little fingers on the injured employee's hands. The employee was hospitalized and required surgical amputation of the right little finger to the second joint, as well as debriding and stitches to the left little finger.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.