Honeywell

An employee was servicing a rooftop exhaust fan when they sustained a partial amputation to the right thumb.

An employee was operating a stand-up forklift in reverse when his left leg was pinned between the forklift and a guardrail. The employee sustained fractures of the bilateral femoral condyles, lateral tibial plateau and proximal fibula with moderate lipohemarthrosis, a contusion of the medial thigh adjacent to the greater saphenous vein without evidence of significant vascular injury, and a subcutaneous hematoma lateral to the left knee.

A temporary employee was using a stand-up reach truck to put away product in a storage rack area. The truck struck the upright supports on a rack, and the first three fingers on the employee's left hand were crushed between the two.

At about 1:00 p.m. on April 28, 2020, an employee was checking a sulfuric acid railcar to ensure that it was empty before it was sent offsite for cleaning and decommissioning. The employee loosened the railcar's dip tube cap with a pipe wrench, then removed it. Residual pressure in the railcar sprayed about 4 pounds of acid into the employee's face, causing chemical burns to the employee's forehead, cheeks and nose.

An employee was on break in his vehicle and had taken his handgun out of his glove box and placed it onto his left thigh/leg. When he was putting the gun back in the glove box, it fired. He was hit in his left thigh, and the bullet exited through his left knee. He was hospitalized.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was performing maintenance on the injection molding cannister vacuum receiver when the pneumatic cylinder actuated. The employee's finger was caught between the cylinder and the wall of the receiver, resulting in a left index fingertip amputation.

An employee was on break in his vehicle and had taken his handgun out of his glove box and placed it onto his left thigh/leg. When he was putting the gun back in the glove box, it fired. He was hit in his left thigh, and the bullet exited through his left knee. He was hospitalized.

On 7/31/2018, at 1:00 AM, an employee was inspecting an auto-pour machine shuttle that was not operating normally. He was bent over with his hand on the rail of the shuttle when the equipment unexpectedly engaged. The shuttle's front roller then amputated his left pinky finger.

An employee was holding a metal diaphragm ring with a nylon stick (tool). The roller used to make the lip on a metal ring (diaphragm) came off of the die inside of the machine, causing the piece to be pulled into the rollers as the machine cycled. The employee's right-hand ring finger was amputated by the rollers.

An employee received an amputation injury to his left middle finger while cleaning a water meter that was on a conveyor when his finger was caught in the power-driven roller on the conveyor.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.