Naval Station Everett

An employee was operating a sit-down type of material handling equipment (MHE). They were turning the MHE with the clamp attachment in the air when the MHE fell over onto its right side. The employee's right foot was caught under the battery cover of the MHE. The employee sustained a chemical burn from the battery and a fractured right ankle.

An employee was driving a snowmobile when it flipped over. The employee suffered a broken rib.

An employee was driving an unloaded forklift outside a building. During a left turn, the forklift drove off the paved area onto an unpaved surface, became unstable, and tipped over. The employee was pinned under the forklift and suffered two broken leg bones and a broken hip.

An employee was riding in a utility task vehicle when it overturned. The employee sustained a broken leg.

An employee was trimming tree branches from an aerial lift. As they were maneuvering the aerial bucket lift from inside, the truck drove over soft ground and tipped over. The bucket lift fell to the ground with the employee tied off inside, resulting in rib fractures.

An employee was conducting welding repairs inside a ballast water tank on a docked ship. The employee began to experience signs of heat exhaustion, resulting in hospitalization.

An employee was stacking steel pipes and securing loose pieces when a unit rolled from the stack and struck his lower right leg. He sustained a lower right leg fracture.

An employee was removing sheet metal from a flat roof. He unhooked his personal fall arrest system (PFAS) to walk to a different location. He stepped on an unsupported end of the sheet metal and the sheet metal folded, causing the employee to fall approximately 15 feet to the cement floor. The employee sustained fractures to his wrist, hip, and femur.

An employee was opening the door of a container. His finger got caught between the container doors, resulting in a fingertip amputation.

An employee was removing bailing wire from the floor. As they bent down to pick up the wire, a strand of bailing wire that was sticking up from the floor went under his safety glasses and struck his eye.

An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.

An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.

An employee was testing and troubleshooting the gang cylinder valve located in the gang area of the sawmill. The employee's fingertip was amputated by the gang cylinder valve.

An employee was unlocking containers on deck. The employee was de-lashing while standing on the edge of the lid. The lashing bar he was holding came off the cone, causing him to turn 90 degrees and strike a railing behind him. The employee sustained four fractured ribs.

An employee parked a side-by-side on the fixed internal ramp aboard a cargo ship. They exited the side-by-side and went to inspect the cargo below. The side-by-side rolled toward the employee and struck them as they were walking toward the edge of the ramp. The employee was knocked off the ramp and landed on the lower deck approximately 8 feet below. The employee was hospitalized with a fractured shoulder.