Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at THALLE CONSTRUCTION COMPANY INC, 429 Taylor Park Rd., GRAND RIVERS, KENTUCKY 42045
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was cutting wood with a table saw when the saw amputated two fingers and damaged two others on his left hand.
An employee knelt in wet concrete while performing work as a concrete finisher and sustained a chemical burn to the right shin. The employee was hospitalized and required surgery.
An employee was helping to unload metal sheet panels from a truck. A panel sat on a piece of wood and the wood broke crushing the employee's right pinky, ring and middle fingers.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.
Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.
A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.
An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.
A mail carrier was delivering mail when aggressive dogs approached. The dog's owner tried to restrain the dogs but one dog broke loose and the mail carrier pepper sprayed that dog. The dog's owner then pushed the mail carrier and he fell on the pavement and injured his neck. The mail carrier was hospitalized.
An employee was installing a fall protection system on a flat roof when they tripped and became entangled in the warning line. They fell approximately 30 feet to the ground below. The employee sustained fractures.
An employee was outside assembling a 500-ton crane. The employee was connecting the rigging to the boom. He leaned forward to attach the lifting plate on the side of the boom and lost balance while bending over. He fell to the ground approximately 10 feet below, landing on his elbow. The employee was hospitalized with a fractured elbow that required surgery.
An employee was using a winch to secure a barge to a dock. The cable of an adjoining winch snapped and struck his left side, causing blunt force trauma and internal injuries to his abdomen.