Struck by object or equipment, n.e.c. · Crushing injuries
At a glance
Federal OSHA recorded a severe workplace injury
at Thalle Construction Company, Inc., 3419 Beacon Point road, PAHOKEE, FLORIDA 33476
on — Crushing injuries, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was helping to unload metal sheet panels from a truck. A panel sat on a piece of wood and the wood broke crushing the employee's right pinky, ring and middle fingers.
An employee knelt in wet concrete while performing work as a concrete finisher and sustained a chemical burn to the right shin. The employee was hospitalized and required surgery.
An employee was inspecting a bridge repair project. A gas-powered, walk-behind pavement saw, being used 12 feet away from the employee lunged forward, cutting his left foot. The employee's fourth toe was amputated and he was hospitalized.
An employee had been reviewing an insulated glass unit. The employee was placing the glass unit back in its box when it slipped out of the box and a chipped corner lacerated the employee's left hand.
An employee was on a truck while using a clamp to secure a quartz slab to an A-frame on the truck. A gust of wind pushed the slab onto the employee, resulting in a dislocated right shoulder and wrist.
An employee was shearing off two inches of metal when the metal kicked up and struck his hand. The employee's left ring and middle fingertips were amputated.
An employee was working on a 35,000-pound I.D. fan. As the employee rotated the blades with his foot, the blades continued to spin, lacerating his right foot and amputating a toe.
More severe injuries in this industry (NAICS 237310)
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.