M.J. ELECTRIC, LLC

At about 10:00 a.m. on July 6, 2021, an employee was doing electrical powerline work when he developed heat stress symptoms. He was hospitalized.

An employee had been climbing a utility pole to install a dolly on the pole and fell approximately 50 feet to the ground below. The employee was hospitalized with a lacerated spleen and internal bleeding.

While pulling electrical line using a tugger and tensioner, an employee came in contact with a live electric current and sustained burns to the left hand.

An employee opened an energized PMH (large electrical box used for power transmission) to verify tags and labels and an arc blast occurred. The employee received first and second degree burns to his right arm, arm pit, shoulder, ear and neck.

On April 13, 2017, an employee was injured when he fell approximately 10 feet from the top outside step/platform of a boom truck while tightening a rope around the bucket.

On December 30, 2023, an employee was pulling a pallet into the back room when a forklift rounded the corner and ran over the employee's right foot. Three of the employee's toes were amputated.

An employee was unwrapping a pallet of empty buckets. The employee stepped backward and was struck by a powered industrial truck carrying a pallet of bucket lids, resulting in a left ankle fracture.

An employee was walking in the racking area to check parts when they were struck by an oncoming forklift. The front wheel ran over the employee's right leg, resulting in fractures to the leg and ankle.

An employee was exiting a trailer for it to be loaded when their right ankle was pinned between a piece of angle iron that was anchored to the floor and a long pallet being pushed by a powered industrial truck (PIT). The employee sustained an ankle fracture and was hospitalized.

A tow truck operator was operating his bed controls on the drivers side when another vehicle crashed into him. The employee sustained fractures to the right femur, hip, and left foot, as well as abrasions to the right knee and a laceration to the right wrist.

An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.

An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.

An employee was working to move a telephone pole when the pole rolled, causing injury to their hip.

An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.

An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.