Ignition of clothing from controlled heat source · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Fraser Shipyards, Inc., 1200 Port Terminal Drive, DULUTH, MINNESOTA 55807
on — Heat (thermal) burns, unspecified, affecting the thigh(s).
Final narrative
On February 6, 2017, an employee was using an oxygen/acetylene torch to remove existing welds between plate steel when a spark ignited his insulated bibs. He suffered burns on the upper thighs of both legs, requiring hospitalization.
On February 21, 2019, an employee was guiding a load of steel that was being moved from a flatbed truck to the ground by a crane. As the load was about four feet from the ground, a rigging failure caused the steel to buckle and strike the employee. The employee was launched into the air about 15-20 feet. The employee sustained a broken arm, collar bone and pelvis.
On August 3, 2016, at approximately 5:30 p.m., while moving from one site on the vessel to another, an employee crawled to the edge of a hatch opening, crawled over the pipe railing, and fell 8 feet into the cargo hold. The employee injured four ribs and suffered a shoulder contusion and a possible bruised lung.
An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.
An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.
An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.
An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.
More severe injuries in this industry (NAICS 336611)
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was preparing to bend a flat bar in a brake press. When the machine was jogged, the stock rotated up and crushed his left middle fingertip against the outer frame of the die. The fingertip was amputated.
An employee was cutting metal with a torch. A piece of metal struck the employee's left foot, causing multiple fractures to metatarsal(s). The employee was hospitalized.
An employee was descending a ladder carrying a bag of trash. He fell, landed on the ground about 10 feet below, and suffered fractures to his right hip and pelvis.
An employee was walking in a garage toward her delivery vehicle. As she stepped down a curb near her vehicle, she fell and landed on the concrete garage floor, resulting in a hip injury that required hospitalization.
Employees were performing maintenance operations on a railroad line when the machine experienced a load conveyor motor failure. While clearing the machine to allow for repairs, an employee pinned the left side of the swing conveyor. The operator on the right side then requested a slight bump to the left to align the right side for pinning. Once the swing was in position, the operator went to pin the right side and the chain tensioner failed, resulting in an abrupt release of the swing chain. The chain snapped back and struck the operator s right hand, resulting in a 1-inch laceration and a fractured fifth metacarpal. The employee was hospitalized and required surgery on the hand.
At about 9:15 a.m. on March 10, 2025, an employee was riding along a hardpack snow-covered roadway on a snowmobile. The snowmobile went over a berm and tipped/rolled, causing the employee to fall to the ground. He suffered a collapsed left lung and was hospitalized.
An employee was decommissioning a substation. The tower switch was being set down on the ground when the switch blade moved. The employee's finger was crushed and amputated.