B3 Integrated Solutions, Inc.

An employee was making modifications to an electrical panel when an arc flash occurred. The employee suffered burns to multiple parts of the body.

An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.

An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.

On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.

An employee had just turned off breakers and was loosening wires on panels when they were shocked by 480 volts of electricity.

A mechanic was replacing the airbag suspension on the front axle of a utility trailer. The airbag blew out, causing an injury to the mechanic's left foot that required hospitalization and surgery.

Employees were installing a truck scale and lowering a module when the injured employee's right ring finger was caught between the module and a side rail. The employee sustained an amputation of the finger to the first knuckle.

An employee was using a 40-ton press to remold a steel part when a steel plug guide shot out from the press and struck the employee in their midsection, causing three broken ribs and a hematoma.

An employee was servicing an air handler at ground level when their left hand contacted a rotating belt. The employee sustained a fingertip amputation.

An employee was calibrating a 100-ton transfer rail using a forklift attachment referred to as an evener which was a metal lifting device. The employee was holding the evener up so that another employee could slide the forklift tines under the evener bar and lift the calibration blocks. During this process one of the forklift tines pinched the employee s right ring finger between the tine and the evener bar resulting in a fingertip amputation.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.