Northwest Express Roadbuilders

An employee suffered a foot fracture while running from the scene of an accident in an interstate work zone.

An employee had just poured concrete on the bridge deck and was using a paving machine to move the concrete when the employee slipped back and fell approximately 10 to 11 feet to the lower roadway from the upper bridge level. The employee hit a metal corrugated pipe and fractured the left knee.

An employee was cleaning off a pallet sorting machine. The employee jumped approximately two feet from the top of the pallet sorting machine to a lower platform. Upon landing, the employee's left ankle rolled, resulting in a fracture that required hospitalization.

An employee was working from the forth rung of an 8-foot step ladder installing radiator covers when the cover began to fall. The employee lost balance and jumped from the ladder, landing on his feet and sustaining a heel fracture.

An employee was standing on their flatbed truck adjusting a cargo pallet. He pulled one of the pallet boards and the board broke, causing the employee to lose his balance and jump 4 feet off the flatbed. The employee landed on a concrete surface and sustained a fractured left heel that required surgery.

An employee was cleaning a single screen machine that had been jammed by a garden hose. The employee exited the machine onto the belt guard and jumped from the belt guard to the ground three feet below. When he landed, he broke his left femur.

An employee was on a catwalk helping to lay down tubing when he lost his balance. The employee jumped approximately 42 inches to the ground and the 30-foot section of tubing struck his left shin resulting in a fracture that required surgery.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.