Mountain Temp Services, LLC

Two temporary employees were attaching a tow-behind air compressor to a truck for transportation. They had tried to use the trailer's attached jack to lift the compressor, but the jack could not raise the trailer high enough to clear the truck's hitch. Instead, both employees manually lifted the trailer and placed it onto the hitch. During this process, the jack separated from the trailer; when the trailer was set down on the truck's hitch, the jack caught the right middle finger of one of the employees. The finger was amputated at the last knuckle.

A temporary employee was cleaning up. As they bent down to pick up a trash pile, a rolling cart rolled into a stack of drywall. The drywall then fell on the employee's right leg, fracturing his tibia.

A temporary employee fell through a manhole at a demolition site, landing 14 feet below and suffering a severe head injury and broken ribs.

An employee was cleaning an elevator shaft pit prior to installation of elevator doors. The employee began descending a step ladder into the elevator shaft pit when the employee fell from the ladder onto a steel pipe at the bottom of the pit, fracturing the right femur. The employee was hospitalized and had surgery. The step ladder legs were not set and locked at the time of the incident.

A flagger was trying to instruct a passenger vehicle to stop when the vehicle's side mirror struck her. She fell to the ground and the truck ran her over, breaking her leg and hip. She was hospitalized.

An employee was transitioning from a ladder onto a roof when the ladder slipped and they fell approximately 20 feet to the ground. The employee was hospitalized with fractures to their pelvis and heel.

An employee was tearing down shingles when they fell approximately 18 feet from a roof to the ground, sustaining a broken ankle.

An employee was climbing a ladder to bring material onto a roof. The ladder slid and the employee fell 16 feet to the ground, resulting in a broken knee.

An employee was performing an inspection of a bridge crane while working from a 19-foot scissor lift. The employee was going to use a pendant to move the crane to access a different portion of the crane for visual inspection. The scissor lift guard rails were below the girder of the crane to avoid contact. The tow arm for the crane collectors contacted the guardrail of the scissor lift and caused it to tip over. The employee stayed inside the scissor lift basket as he fell to the floor. The employee sustained fractures to the right arm and hip.

An employee was on a forklift that was elevated approximately 20 feet and was auditing inventory. The forklift malfunctioned and the employee fell down to the surface below, causing them to sustain multiple fractures.

A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.

A temporary employee was rigging secondary steel when the steel joist fell to the ground and struck his lower left leg, resulting in fractures to the tibia and fibula.

A temporary employee was helping set up a stage for a concert. The employee was run over by a mobile cart and sustained a toe amputation. The employee was hospitalized.

The injured employee was operating a reach truck and stopped at an intersection within a warehouse. After a brief a conversation, another employee's reach truck accelerated unexpectedly and struck the injured employee's stationary truck crushing his foot. He sustained fractures to his left foot and toes requiring hospitalization and surgery.

A temporary employee was operating a plastic strapping machine on an assembly line. The machine wrapped the employee, causing crushing injuries to their ribs and a kidney. The employee was hospitalized.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.