Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Quad/Graphics, Inc., 56 Duplainville Rd., SARATOGA SPRINGS, NEW YORK 12866
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was operating a leather sewing machine when a cardboard guard dropped off the machine. As he reached to the floor to pick it up, his left pinky fingertip was caught and amputated in the drive belt where the cardboard guard had been.
An employee was trying to remove a blockage in a dust collection system. The airlock fan activated and amputated three fingertips on the employee's right hand.
An employee was disconnecting a truck from a trailer. While pulling the fifth-wheel release that the trailer was attached to, the employee lost balance and fell backward onto the concrete pavement, resulting in a fractured T12 vertebra.
Maintenance employees were replacing a gear box in the stacker of a press. After the replacement was complete, the stacker was restarted. The maintenance employees then heard a loud noise coming from the drive chain area and the injured employee went to check the chain tension when the machine amputated his right index fingertip.
While walking towards the office inside the warehouse, an employee slipped on a piece of debris (green strap) that was on the floor and fell. The employee sustained a fractured right hip.
An employee was helping to change out a cylinder on a press. He was putting the cylinder arms down to put the cylinder in place. As he stepped over the driveshaft to pull the pin and roll the cylinders, he lost balance and started to fall forward. He dropped the cylinder arm to regain his balance and the arm came down on his right index finger and amputated the fingertip.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 323110)
An employee opened a 480-volt breaker box and reached inside the breaker box when an uninsulated tool came in contact with one of the legs, causing him to be electrocuted. The employee's arm also got caught on the box, resulting in breaks to both bones in the forearm.
An employee was disconnecting a truck from a trailer. While pulling the fifth-wheel release that the trailer was attached to, the employee lost balance and fell backward onto the concrete pavement, resulting in a fractured T12 vertebra.
An employee was operating a UV coater machine when it began to make a grinding noise. The employee was investigating the vibration of the machine when a gear caught their right index finger and amputated the tip.
A temporary employee was operating a seal machine to seal paper bundles. A jam occurred when the paper and plastic did not properly align to secure the seal. The employee went to clear the jam and the blade on the machine amputated their right middle finger.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.