Direct exposure to electricity, unspecified · Electrocutions, electric shocks
At a glance
Federal OSHA recorded a severe workplace injury
at American Maplin Corporation, 823 S Bypass Rd , MCPHERSON, KANSAS 67460
on — Electrocutions, electric shocks, affecting the bODY SYSTEMS.
Final narrative
An employee was on a ladder helping to install new lighting fixtures inside a drop ceiling when the employee contacted a live bare conductor and received an electrical shock, requiring hospitalization.
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 333220)
An employee was completing setup of a job on a plastic molding machine. The employee was moving a molding tool within the machine using an overhead crane. Their left middle finger was caught between the molding tool and the eye bolt resulting in a fingertip amputation.
An employee was moving a piece of molding equipment on a pallet using a pallet jack. The molding equipment tipped over and pinched the employee's middle finger, resulting in a partial amputation without bone loss.
The employee was working with a plastic lid press machine used for installing lids on cooler products. The employee was clearing a stuck plastic lid and their hand was caught in a pinch point resulting in a partial amputation to a finger.
An employee was performing maintenance on a clean-in-place (CIP) machine when the tip of the employee's thumb was caught in a pinch point and amputated.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.