JOHNSON BROS. CORPORATION, A SOUTHLAND COMPANY

An employee was guiding a crane onto crane mats when one of the leading transitional mats separated and struck the employee in the lower right leg. The employee sustained a fracture to the lower leg and was hospitalized.

The injured employee was assisting with backfilling an excavation. The employee was kneeling on the pipe with both knees and was holding a piece of plywood while their right hand sat on the second pipe next to the hole. While the excavator was backfilling the trench he was shaking the bucket to allow the dirt to come out. A piece of concrete fell out of the bucket and struck the back of the employee's right hand, causing a displaced fracture to the metacarpal bone of the index finger, a fracture to the metacarpal bone of the middle finger, and a laceration.

A crew was preparing to remove the capital form. The injured employee went to unscrew the formwork nut with a wrench and pipe bar. The wrench slipped on the nut, causing the employee's left little fingertip to become wedged between the wrench and the nut. The employee sustained an amputation to the finger.

An employee was assisting with cleaning the distributor truck's tank. The distributor tank was still hot causing a rapid release of stems, burning the employee and causing them to fall from the tank to the flatbed work truck. The employee sustained burns to the face and hands, a head contusion, and a laceration above the right eye.

An employee was standing next to staged formwork, about 3-4 feet high. The formwork shifted and fell on the employee's lower left leg, fracturing the ankle.

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.