Precision Pump & Valve Service, Inc.

An employee was running pipe into a hole on a rig floor. He was still running the other joint into the hole when the laydown machine shot the joint of pipe. The pipe hit the employee in the jaw and he fell backward, suffering a fractured cheekbone.

An employee was in the yard area on a forklift pulling lumber. Inclement weather began and the employee stopped the forklift and was walking to a safe location when they were struck by flying debris from the high winds or tornado. The employee sustained a leg fracture.

An employee was working at a job site when something flew into his eye. He was hospitalized with a cut on his cornea.

After reassembly work on a ready-mix truck, an employee turned the truck on to check for leaks. The employee was standing on the truck platform, about 3 feet off the ground, when he heard an air leak. As he was turning off the truck, a flying bolt from the plate assembly struck his forehead and broke his skull. He was hospitalized.

An employee was using an air hammer when a piece of metal struck their eye.

An employee was positioning dunnage on a trailer while pipe was unloaded from a forklift. A pipe fell and the employee's right thumb and index finger were caught between the pipe and a piece of dunnage. The thumb was crushed, and the index fingertip was amputated.

An employee was using a lifting sling on a crane to move a straight-bar bundle and place it on top of an existing bundle. When moving the lifting sling, it became pinched between the bundle and a wood cleat. The bundle then fell onto the employee's left foot, resulting in crush injuries.

An employee was stacking metal tubes using a forklift. A stack became unstable and the employee got out of the forklift to steady it, instructing his helper to get into the forklift. The forklift movement caused some tubes to fall and strike the employee, resulting in an open fracture of his left hand.

An employee was setting up a flexible gear coupling hub in a lathe, preparing to bore it out to fit a shaft. The hub assembly was not secured in the chuck when the crane support was removed, and the employee's right little finger was caught between the hub assembly and the inside of the lathe. The fingertip was amputated.

An employee was using a crowbar to loosen a flat bar when the crowbar struck the employee's right eye. The employee was hospitalized and required surgery.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.

An employee was climbing down a ladder when it slipped. The employee fell, suffering a broken scapula and broken ribs. The employee was hospitalized.

An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.

An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.