Fender Marine Construction Inc.

An employee was preparing pilings on a tied-off barge when they tripped and fell three feet from the barge to the ground. The employee sustained a lower right leg and ankle displacement.

An employee was stepping off a boat onto a rocky river bank. He tripped due to the uneven walking surface and fell, suffering a broken right tibia.

An employee was preparing pilings on a tied-off barge when they tripped and fell three feet from the barge to the ground. The employee sustained a lower right leg and ankle displacement.

An employee was taking a discharge hose off a barge. When he went to throw the hose onto the dock, it caught his glove and pulled him with it. He fell about 5 feet off the barge, suffering a broken collarbone and rib.

An employee was rigging and guiding loads during crane operations. The crane lifted a 212-pound generator and tipped over with the boom crushing a nearby structure. Two employees on top of the structure jumped clear of the falling crane boom. A stanchion pole impaled the injured employee's upper thigh and they sustained lacerations to the thigh and buttocks. The second employee did not require medical treatment.

An employee had just climbed down from a 6-foot A-frame ladder and was trying to fold it. With both feet firmly on the deck of the barge, the employee took a step back and caught his foot on the lowest rung of the ladder. The employee fell backward and landed on a steel mooring cleat mounted to the outside edge of the barge. The employee then rolled off the barge and into the water 3 feet below. The employee sustained a lower back contusion.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.