Ignition of clothing from controlled heat source · Third or fourth degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Altice Technical Services, Inc., Route 60, RAINELLE, WEST VIRGINIA 25962
on — Third or fourth degree heat (thermal) burns, affecting the multiple body parts, n.e.c..
Watch Altice Technical Services, Inc. — freeGet an email when a new federal OSHA severe-injury report for Altice Technical Services, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
On April 10, 2018, at approximately 10:40 a.m., an employee was working from a bucket truck, installing a cable to a new utility pole, when his left shoulder made contact with a primary power line. His clothing then ignited, resulting in third degree burns to his left shoulder, neck, and face. He was hospitalized.
HospitalizedMultiple body parts, n.e.c.Clothing, unspecified
An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.
An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.
An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.
An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.
More severe injuries in this industry (NAICS 517510)
An employee in an aerial bucket was attaching a cable to a pole when they contacted a power transmission fuse and sustained burns to their left hand, arm, and shoulder.
At 2:30 p.m. on February 8, 2024, an employee fell while installing cable, landing about 20 feet below and suffering a broken arm. The employee was hospitalized.
An employee was on a ladder that was leaned against a wire strap while installing cable service. The ladder slipped and the employee fell, resulting in a broken lower left leg.
An employee was working from the bucket of a bucket truck. After completing his work, the employee lowered the boom of the truck and exited the bucket onto the truck. As he was exiting, he tripped on the door frame opening, fell onto the rear deck of the truck, and then to the ground. The employee suffered an injury that required hospitalization.
An employee was standing on a ladder to perform repairs on a cable case when they fell approximately 6 feet to the ground, resulting in a left foot fracture and dislocation.
An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.
An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.
An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.