Quad/Graphics, Inc.

An employee was trying to remove a blockage in a dust collection system. The airlock fan activated and amputated three fingertips on the employee's right hand.

An employee was disconnecting a truck from a trailer. While pulling the fifth-wheel release that the trailer was attached to, the employee lost balance and fell backward onto the concrete pavement, resulting in a fractured T12 vertebra.

Maintenance employees were replacing a gear box in the stacker of a press. After the replacement was complete, the stacker was restarted. The maintenance employees then heard a loud noise coming from the drive chain area and the injured employee went to check the chain tension when the machine amputated his right index fingertip.

While walking towards the office inside the warehouse, an employee slipped on a piece of debris (green strap) that was on the floor and fell. The employee sustained a fractured right hip.

An employee was helping to change out a cylinder on a press. He was putting the cylinder arms down to put the cylinder in place. As he stepped over the driveshaft to pull the pin and roll the cylinders, he lost balance and started to fall forward. He dropped the cylinder arm to regain his balance and the arm came down on his right index finger and amputated the fingertip.

An employee was delivering mail when they tripped on a curb and fell to the ground, resulting in a kneecap injury.

An employee was leaving work when they tripped over a curb in the parking lot and fell into a wall, resulting in a fractured left humerus.

A nurse was visiting the home of a patient for requested treatment. She tripped on her gown while going up the steps to the property, falling and fracturing her left femur.

An employee tripped on a step while entering a house. The employee suffered a broken right femur and was hospitalized, requiring surgery.

An employee was walking up an escalator that was out of service when they tripped on a step, fell, and suffered a closed fracture to the right femur as well as a dislocated right patella.

An employee tripped over an object and fell to the ground, resulting in right elbow and right hip fractures.

An employee opened a 480-volt breaker box and reached inside the breaker box when an uninsulated tool came in contact with one of the legs, causing him to be electrocuted. The employee's arm also got caught on the box, resulting in breaks to both bones in the forearm.

An employee was disconnecting a truck from a trailer. While pulling the fifth-wheel release that the trailer was attached to, the employee lost balance and fell backward onto the concrete pavement, resulting in a fractured T12 vertebra.

An employee was operating a UV coater machine when it began to make a grinding noise. The employee was investigating the vibration of the machine when a gear caught their right index finger and amputated the tip.

A temporary employee was operating a seal machine to seal paper bundles. A jam occurred when the paper and plastic did not properly align to secure the seal. The employee went to clear the jam and the blade on the machine amputated their right middle finger.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.