M1 Support Services

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

A maintenance crew was working on a helicopter. The injured employee climbed the back of the helicopter to attach a tie-down rope to the aircraft rotor. While he was securing the rope to the rotor, it rotated and struck him, causing him to slide down the side of the helicopter and strike the fuel fuselage before impacting the ground. The employee fractured his left tibia and fibula.

An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.

An employee was walking through the maintenance bay when she tripped and fell to the floor. The employee was hospitalized with a dislocated femur and a left acetabular fracture.

An employee was walking into a hangar when they slipped on a wet floor, causing them to fall and hit their head. The employee sustained a head laceration.

An employee was walking to their truck to look for a lid. When they stepped between the truck and a dock plate, they sustained a knee injury that required surgery.

An employee was standing on plant bed timbers, using a powered hand trimmer to trim the shrubs in the plant bed. The timber gave way, breaking into several pieces. The employee lost balance and fell with the trimmer in his hand. He suffered a severe laceration to the right wrist and hand.

A mail carrier slipped on ice and sustained a strain that required hospitalization.

An employee was loading phosphoric acid onto a rail car and preparing to secure the rail car for transport. While repositioning the loadout spout to secure it back to the drip pan holster on the dock, the spout contacted the handrail of the rail car, causing the employee to lose balance. The employee stepped back and their right foot entered the opening for the rail car, causing him to twist/pivot on his left leg. The employee's lower left leg was fractured.

On November 14, 2023, an employee was receiving a delivery from a truck when some of the merchandise fell from the truck s lift and struck him. He then fell to the ground and his head struck the sidewalk, resulting in an injury that required hospitalization.

Two employees fell from an access bridge while entering an aircraft to perform maintenance. They landed on the ground about 20 feet below, where one of them lost consciousness. One employee sustained a fractured knee and another employee sustained a back strain/sprain. Both employees were hospitalized.

An employee experienced sharp pain in his lower torso area while loading baggage into the front cargo pit of an aircraft. The employee sustained a hernia.

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

On September 11, 2025, an employee was lowering a railing system on an aircraft fueling cart when his gloved right ring finger was caught in the folding railing system, resulting in a fingertip amputation that required hospitalization and surgical reattachment.

An employee was working at ground level when an aviation engine cylinder weighing 30 pounds fell from a seven-foot high shelf and struck the employee on the head. The employee suffered a fractured skull and was hospitalized.

An employee was servicing an exterior mounted environmental control unit while on a 10-foot ladder. He pushed through a pre-made knockout hole on the panel. Upon bringing his arm down, a sharp area along the panel frame lacerated the top of his hand. The employee required surgery.

On 7/31/2025, an employee was training to ride an ATV when it went into a draw and she went over the front of the ATV, landing on the ground. The employee sustained a fractured arm.

An employee was standing behind a frac pump. A discharge hose failed and the employee was burned by hot water on the left upper abdomen. The employee was hospitalized.

An employee working as a contracted firefighter was using a bulldozer to push back an active fire line when they became entrapped in flames, resulting in first- and second-degree burns.

An employee was assisting with the delivery of pipe racks to the drilling rig. The driver was releasing the tie-down lock straps that were holding the pipe racks on the trailer. When the last strap was released, one of the pipe racks rolled off the trailer and struck the employee while they were on the passenger side of the trailer bed. The employee sustained an open wound to the hand and fractures to their left leg and spine.