Millard Lumber Inc.

An employee was working on a truss press machine. It closed while the employee's left hand was still in it, and the tip of the employee's left thumb was amputated.

An employee's finger was amputated when a piece of unsecured plywood slid off of a forklift and smashed the left-hand pinky finger between two plywood stacks.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

On September 5, 2025, an employee was installing gang plates on a structure when the side walls fell and hit her head. She then fell onto her back and the side wall pressed her to the ground, resulting in hospitalization due to an ilium fracture and a transverse process fracture on the right side.

An employee was blowing cellulose insulation into the open attic area of a manufactured home. While the employee was holding the insulation hose, it caught on the guardrail of the catwalk/suspended walkway leading into the attic. The tugging motion caused the employee to lose their footing and step onto the sheetrock ceiling. The employee fell through the ceiling to the ground about 8 feet below and suffered a broken lower left leg. The employee was hospitalized.

An employee was going between a ladder and a wall to repair a wall in the utility room. A brad-nailing gun was hanging on a piece of wood on the side of the ladder. The employee contacted the brad nailer and the trigger was pushed into the wooden piece. The brad-nailing gun actuated and shot a 2-inch brad into the employee's abdomen.

An employee was on a scaffold caulking and painting a manufactured home. She fell off the scaffold an estimated 6 to 8 feet, landing on the concrete floor. The employee suffered upper body injuries and was hospitalized.

An employee was going up a ladder from the first level roof to the second level roof. The ladder slipped and the employee fell approximately 8 to 10 feet to the surface on the first level. The employee sustained fractures to three ribs and bruises on their arms and hands.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.