Ignition of vapors, gases, or liquids · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at AECOM, 2650 Louisiana Avenue, FORT POLK, LOUISIANA 71459
on — Heat (thermal) burns, unspecified, affecting the head and trunk.
Final narrative
An employee was welding on a newly fabricated fuel tank when a flash fire occurred. Residual fumes in the tank ignited and flames exited the tank opening, causing burns to the employee's face and chest.
HospitalizedHead and trunkGasoline, diesel fuel, jet fuel
An AECOM maintenance employee was troubleshooting a malfunctioning encoder device. To access the device, the employee had to stand on top of a tank holding a caustic cleaning solution, about 3 feet off the ground. The employee's left leg slipped through one of the access covers and was immersed in the caustic solution up to the knee. The employee suffered third-degree burns to the lower leg.
An aircraft mechanic was conducting maintenance on an aircraft from the ground. When he extended a boarding ladder, which is built into the aircraft, his left thumb was caught in pinch points and amputated from the nail to the knuckle.
An aircraft mechanic was working on the left wing of an F-18 aircraft removing a component section of the wing known as a flight control surface. During this process the employee pushed on a bolt with his finger. When the bolt moved, the employee's right index finger followed and was caught in a pinch point by the weight of the falling component. The fingertip was amputated.
An employee was cleaning a cordless drill. As they applied brake fluid to the drill and pulled the trigger, the fluid ignited. The employee suffered burns to the face, hands, and arms.
An employee was spraying glue to the floor of an enclosed cargo trailer. The fumes made contact with the heater causing a flash fire. The employee suffered burns to their face and right hand.
An employee was replacing a valve in the gas line to the fryer. The shutoff valve malfunctioned resulting in a gas leak that then ignited. The employee sustained burns requiring hospitalization.
An employee was on a four-step work stand while sanding an area of an aircraft. He was climbing down the work stand when he tripped over an air hose and fell to the level below, resulting in a fractured femur.
A Bureau of Land Management (BLM) employee was assisting a fire crew with clearing a forest trail. The employee was struck in the left leg by a fire-rated chainsaw. The chainsaw struck the employee underneath their chaps and above their boot. The employee was hospitalized and required surgery.
An employee handed a fuel hose to another employee at a gas station pump and then turned around, tripped over the hose, and fell to the ground. The employee was hospitalized with a fractured hip.
An employee was conducting fire suppression operations on a wildfire. He pulled a hose from the engine. He then charged the hose and began to put on his gloves. A flareup occurred and the employee sustained burns to his face and hands.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.