Jack-knifed or overturned, nonroadway · Bruises, contusions
At a glance
Federal OSHA recorded a severe workplace injury
at A-1 FIBERGLASS INC., 4495 S. GUNPOWDER CIRCLE, HASTINGS, NEBRASKA 68901
on — Bruises, contusions, affecting the leg(s), unspecified.
Final narrative
An employee was driving a forklift on an unpaved road. The forklift left the road and tipped over in a ditch. The employee's legs were pinned under the forklift and sustained bruising.
HospitalizedLeg(s), unspecifiedForklift, order picker, platform truck-powered
An employee was clearing snow using a skid loader. The loader's bucket hit something solid, causing the skid loader to stop abruptly. The employee's chest collided with the safety bar inside the loader, causing the employee to lose consciousness. He was hospitalized.
An employee was operating a sit-down type of material handling equipment (MHE). They were turning the MHE with the clamp attachment in the air when the MHE fell over onto its right side. The employee's right foot was caught under the battery cover of the MHE. The employee sustained a chemical burn from the battery and a fractured right ankle.
An employee was driving an unloaded forklift outside a building. During a left turn, the forklift drove off the paved area onto an unpaved surface, became unstable, and tipped over. The employee was pinned under the forklift and suffered two broken leg bones and a broken hip.
An employee was trimming tree branches from an aerial lift. As they were maneuvering the aerial bucket lift from inside, the truck drove over soft ground and tipped over. The bucket lift fell to the ground with the employee tied off inside, resulting in rib fractures.
More severe injuries in this industry (NAICS 325991)
An employee was working to unclog a feeder that feeds raw material into an extruder to make plastic/polymer. The slide gate closed on his right hand, amputating three fingers between the first and second knuckles as well as cutting the thumb tip.
An employee was operating an overhead crane and using a hoist to lower a metal tipper bin. The tipper lowered onto their right hand, crushing their right thumb and resulting in a fingertip amputation.
An employee was unclogging a granulator when the rotor pulled his fingers in. His left index, middle, and ring fingers, as well as his right thumb, index, middle, and ring fingers were amputated. The employee was hospitalized. The machine was not guarded at the time.
On March 3, 2025, two employees were working on a blender. The injured employee was removing contaminated pellets from the blender. Another employee went to elevate a tilter that was feeding the blender when the blender auger activated and crushed the injured employee's left leg. The employee's leg was medically amputated 4" - 6" below the knee. The machine was guarded at the time.
An employee was performing maintenance on a pelletizer. When they rotated the drum, their left index finger became caught between the pelletizer blades and the bed, resulting in a fingertip amputation.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.