Lexicon, Inc.

An employee was using a sleever bar to move a checker plate into place and secure it to the floor of a structure in the melt shop. The sleever bar became stuck and the employee used his left hand to lift the checker plate up enough to free the sleever bar. Once the bar was freed, the checker plate came down and pinched his left index finger between two pieces of plate. The employee suffered an amputation of soft tissue at the fingertip, which required hospitalization.

On May 16, 2025, an employee crossed over a stand to support a wide flange beam they were fabricating. The beam rolled over onto their lower right leg and foot, resulting in fractures.

An employee was placing a steel I-beam when it became stuck and would not settle onto the flanges. The employee was moving the beam and when it became unstuck and crushed the fingers on his left hand. The employee was hospitalized and required surgery.

The injured employee was assisting a crew to install a crane rail on an overhead crane girder. He was on the 40' x 10' grated surface between the crane rails positioning himself to receive the end of the crane rail. The crane rail was being pushed on rollers toward the employee's location and as he tried to pry the end of the crane rail up to get it on top of the next roller, he lost his balance and fell 36 feet to the ground below. The employee sustained fractures to their right ankle, pelvis, and left arm. The employee was wearing a personal fall arrest system, but was not tied off at the time.

An employee was installing drive shafts on an overhead crane. The drive shaft was rigged about 17 feet up with a wire rope choker. The drive shaft began slipping through the rigging, when it slid down and struck the injured employee's hard hat. He was knocked to his knees and landed on his right knee. The employee sustained an amputation to the right leg below the knee.

An employee was sweeping behind a guardrail and stepped on the lower portion of the guardrail when he lost his balance. As he stepped back, his foot became stuck between the guardrail and a transformer, resulting in a compound fracture of left tibia and fibula.

An employee was repositioning a chill adder so that the pig tubs behind it could be removed. The employee lost their balance and their finger was pinched between the chill adder and the pig tub, resulting in a fingertip amputation.

An employee was backing up a stand-up forklift. The vehicle struck a guard and a wooden table. Upon exiting the forklift, the employee's left leg became caught between the table and dock guard, causing a fractured leg.

An employee was working on a shoring scaffold with another employee to strip plywood from cement. The employees threw a 4x4 piece of forming down and it got stuck on the beam of the scaffold. The injured employee went to grab the forming when their left ring fingertip was pinched between it and the beam, resulting in a partial amputation.

An employee was using a torch to trim the foundation for a compressed air tank so the tank would fit in place. His left hand was caught between the tank and the steel bar foundation structure; the hand was crushed and burned.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.