Ignition of clothing from controlled heat source · Second degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Vista Speciality Alloys, LLC, 800 Martin Luther King Dr, ADAIRSVILLE, GEORGIA 30103
on — Second degree heat (thermal) burns, affecting the multiple body parts, n.e.c..
Final narrative
An employee was standing near a cannon-type heater trying to warm himself. The employee's shirt ignited due to contact with the heater. The employee sustained second degree burns to the left front, side, and back torso, and the left thumb, fingers, and palm.
HospitalizedMultiple body parts, n.e.c.Blouses, shirts, dresses, trousers, skirts
An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.
An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.
An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.
An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.
More severe injuries in this industry (NAICS 332313)
A steel tube fell from a straddle truck onto an employee's foot, causing the steel toe of the employee's shoe to press into the employee's left foot. The employee sustained fractured phalanges and was hospitalized.
An employee was unloading materials from the back of a flatbed trailer. The employee fell off the back of the trailer approximately 4 feet to the ground below, resulting in a fractured left collarbone and fractured ribs. The employee was hospitalized.
An employee was bending material in a mechanical brake press when the press rotated and caught his right hand. His finger was crushed between the die and a steel plate, resulting in amputation of the finger.
An employee was cleaning pans containing adhesive by pouring acetone into the pans. After soaking, the employee used a plastic spatula to scrape the paint from the pan. During scraping, a fire spontaneously started underneath the employee near the pan. The employee threw the container of acetone out of the way to avoid it catching on fire, and spilled acetone onto his clothing, causing the fire to spread. The employee suffered burns to both hands and the right calf.
The injured employee was assisting a co-worker to transfer a V-baffle (large piece of angle iron weighing 736 lbs.) into a vessel shell. The injured employee stepped off the end of the vessel and fell backward. The employee sustained a dislocated left shoulder, a fractured left wrist, a fractured lower right leg, and a laceration to the left eyebrow.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.