Caterpillar, Inc.

On September 13, 2025, an employee had been working at an outdoor event. At the end the day, she was walking around outside the facility to make sure everything was put away and felt overheated. The employee was hospitalized for heat-related illness.

On September 5, 2025, at approximately 7:35 AM, a temporary employee was at the engine block rollover machine. Their left index fingertip was caught and amputated between a pneumatic part and a guard.

On June 27, 2025, at approximately 8:35 AM, an employee was operating a box maker machine when their left middle fingertip was caught by a chain and sprocket. The employee's fingertip was partially amputated without loss of bone or the fingernail.

An employee had just put a dock plate in place. While stepping back over the plate, the employee tripped and fell onto it. The employee suffered a broken hip.

On April 8, 2025, an employee entered an engine test cell to de-harness an engine and was exposed to hot water resulting in burns and hospitalization.

A mixer truck driver was delivering a load of concrete to a jobsite. The driver was operating the controls outside of his truck when a 6x10-foot fascia wall gave way. One of the concrete fascia panels struck the driver's right calf resulting in amputation of the leg below the knee.

An employee was installing sheet piles when a pier collapsed and they sustained a broken leg.

An employee was receiving a 32-by-8 panel wall that weighed 3,500 pounds. As the crane was going up, the cable of one of the clanks became caught on the panel wall. The panel wall collapsed and struck the employee's right leg, resulting in right leg fractures and amputation below the knee.

An employee was moving conveyors in a warehouse to another location using rolling casters. The legs became detached from the bottom of the conveyor, and the employee's right index finger was caught in the conveyor pinch point, resulting in a fingertip amputation.

An employee was participating in demolition work when a non-structural wall collapsed on him. The employee was hospitalized with a fractured shoulder.

An employee was working behind a stack of steel I-beams (stacked 2 columns deep and 4 levels high on the floor) while a forklift was pushing the stack. When the forklift took off the second-to-last beam, the last one was pushed over, causing it to fall to the ground and strike the employee. The employee sustained a fracture to the right leg.

An employee was lifting a flat sub (sheet steel) in the flats robot cell (weld area). He was operating a hoist when his left little fingertip got caught between the lifting device hook and the flat sub. The employee sustained a partial transphalangeal amputation.

An employee was underneath a 35-foot boom truck and adjusting the transmission linkage when the truck jumped over the wheel chocks and rolled over the employee's right leg, resulting in a fracture.

A crane was being used to lift a debris tank from a rack. The tank crushed the employee's right hand, causing amputations to the employee's right ring finger and little fingertip.

An employee was removing a small sheet metal part out of the die of the brake press. The foot pedal was pressed, causing the part to lift and crush their left thumb against the die. The employee suffered an amputation to the thumb tip including the loss of flesh and the fingernail.

An employee was working to deliver mail to an apartment building. She was waiting for a customer to move, to obtain clearance to the mailboxes. The door swung inward and closed on her right little finger. The top half of her finger was surgically amputated.

An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.

On October 30, 2025, an employee was working to adjust a stackable metal shipping container. As the container dropped into place, it caught the employee's hands in an area between the upper and lower cross-members. The employee suffered a laceration to the left ring finger that required stitches, bruising to the right ring finger, and fractures to the right middle finger that necessitated medical amputation of the fingertip.

An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.

An employee was setting up communication equipment for a meeting. They were walking and tripped over a speaker on the ground. The employee sustained a leg injury.