Caught in or compressed by equipment or objects, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at GKN Sinter Metals, 1 Airport Road, EMPORIUM, PENNSYLVANIA 15834
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was aligning/installing the bottom punch in a forging press. An airline was hooked up to extend cylinders for the die pod. The airline became disconnected and the die pod fell, pinching the employee's left index finger between the die and the punch. The finger was amputated to the second knuckle.
An employee was operating a scissor lift to raise pipes near the ceiling. His hand was on the rail of the scissor lift when his left pinky fingertip was caught and amputated between a piece of electrical conduit and the scissor lift railing.
An employee was trying to unjam a part on a sort table when a part slide mechanism pinched her right middle finger between the air-actuated slide and a part. As she pulled her hand out to remove her finger, her fingertip was amputated just below the cuticle.
On January 6, 2015, at approximately 11:30 p.m., an employee was performing a change over in the secondary turn cell when the clamp/unclamp feature was activated. The employee's fingertips on both hands were caught behind the chuck of the lathe. On the left hand, the third and fourth fingers were amputated.
An employee was changing mud cups in the hopper cylinders of a concrete pump truck. The cylinders moved and three of the employees fingers were amputated.
An employee was standing on the rig floor next to a polishing unit. His hand was placed on the polishing unit when the pump was lowered, resulting in amputation of their right thumb, ring, and middle fingertips.
An employee was using air to blow out the air wash to the blender and grinder station. As the employee reached to verify that the air wash was clean, the unit pinched and amputated their fingertip.
An employee was retrieving a lost drill pipe with a lifting bail when their left thumb got pinched between the table and handle of the lifting bail while trying to re-thread the pipe to lift it out. The employee suffered an amputation to the left thumb.
An employee was removing a core chuck from a stationary roll when their right ring finger was pinched between the chuck and the roll. The employee's fingertip was amputated.
More severe injuries in this industry (NAICS 332117)
An employee was running a sizing press. He was changing totes and needed to verify the sizes on the new tote of parts. While he was removing a part, the machine, operating in inch mode, crushed his left index fingertip between the pin, punch, and die. The employee sustained an amputation to left index finger. The machine was unguarded at the time of the incident.
An employee was removing a mold (weighing over 50 pounds) from a press machine to take the mold to another location. When he put the mold down, it dropped onto his finger and amputated his fingertip at the knuckle.
At 9:20 a.m. on Saturday August 17, 2024, an employee was running a sizing press machine when his right hand was caught in the press. The employee sustained an amputation of his ring finger at the knuckle and injuries to his index, middle, and little fingers that required stitches.
An employee was working on a sizing press. They were putting a part into the sizing press when the machine cycled. The employee sustained an amputation to their right index finger.
An employee was cleaning the tooling in a mechanical power press when the ram drifted down and caught the employee's right middle finger. Their fingertip was amputated.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.