Cianbro Corporation

Employees were developing a plan to inspect/reinstall a perforated plate (precipitator transition piece) that dropped out from underneath the east inlet nozzle. The injured employee's left hand became caught in the plate when it slid, amputating their middle fingertip.

An employee had been drilling holes using a digger derrick. While he was trying to remove the auger, his ankle rolled and he fell off the machine's base plate to the ground. His ankle was broken.

A worker cut a 4-foot x 6-foot x 5-inch piece of concrete slab from the operating floor, which fell toward the barricaded area in the basement. As the concrete slab fell, it struck a piece of equipment and was deflected to an area outside of the barricade. The slab then struck an employee standing nearby, lacerating the employee's leg.

An employee was unloading a truck when he experienced pain. He was hospitalized with a hernia.

An employee was cutting pipe when they sustained a laceration to the face. The employee was hospitalized.

An employee suffered two fingertip amputations while working at a plant.

On September 25, 2023, an employee was working in the body department installing doors, hoods, and tailgates. The employee finished their shift and was hospitalized later that evening for a back injury.

An employee was operating a scissor lift and fractured their right ankle.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.