NEW LONDON, CONNECTICUT—
Marjam Supply Company, Inc.
Nonroadway noncollision incident, n.e.c. · Bruises, contusions
At a glance
Federal OSHA recorded a severe workplace injury at Marjam Supply Company, Inc., 500 Bank Street, NEW LONDON, CONNECTICUT 06320 on — Bruises, contusions, affecting the scalp.
Final narrative
An employee was using a forklift to offload drywall. While sitting in the forklift, the forklift became unbalanced causing him to hit his head on the top rail, suffering a contusion to the top of his head.
More severe injuries at Marjam Supply Company, Inc.
TAMPA, FLORIDA—
MarJam Supply Company, Inc.
The injured employee was pulling a sheet rock cart loaded with 8 cement boards while another employee was pushing it. A tire went off the sidewalk and the cart was about to tip over. The injured employee slipped in "sand" trying to move out of the way and the cement boards fell on top of the employee. The injured employee was hospitalized with a fractured ankle and a lower back injury.
View Marjam Supply Company, Inc.'s full OSHA safety record →
Similar incidents · Same event type
GOSHEN, OHIO—
Seven Brothers Farm
An employee was using a dozer to clear a plot of land. The dozer struck the ground after getting stuck on a tree stump, causing the employee to hit their head on the cab roof. The employee sustained a spinal compression injury.
CHAMPAIGN, ILLINOIS—
David Miller
On August 31, 2023, an employee was operating an excavator to complete a demolition job. As the excavator drove into the first floor of the building, the floor collapsed. The vehicle and employee dropped approximately 8 feet, causing the employee to sustain a back injury.
NEWARK, DELAWARE—
Delaware Lawn Crew, LLC
An employee was standing on a walk-behind lawn mower when the mower spun out of control. His right ring fingertip became caught in the handlebar, resulting in an amputation.
NORMAN, OKLAHOMA—
SWH Construction, LLC
An employee was loading a bundle of 3/8-inch rebar using a standup skid loader. While transporting the load, the equipment tipped forward, throwing the employee over the controls and into the mast of the skid loader. The employee sustained several teeth avulsions, a mouth laceration, and bruising/swelling around the face.
SEGUIN, TEXAS—
Hakes Brothers SATX, LLC
An employee was driving a forklift to deliver lumber to a work site when the forklift tipped forward onto the forks. The employee struck his head on a metal railing on the forklift, resulting in a laceration, a concussion, and temporary loss of consciousness.
More severe injuries in this industry (NAICS 444190)
SOUTH SETAUKET, NEW YORK—
The Home Depot USA, Inc.
An employee was unloading freight from a truck when a stack of doors fell over and knocked the employee to the ground. The employee sustained a fractured femur.
DENVER, COLORADO—
White Cap L.P.
An employee was performing rebar fabrication using a bending machine. The employee's glove became caught in the area where the rebar bend overlaps onto itself. The subsequent bending/cutting caused the two overlapping portions to squeeze together and amputate approximately 1/4" of his left index fingertip.
GRAND ISLAND, NEBRASKA—
Builders Warehouse, Inc.
An employee was building wood detail blocking and a wood member needed to be resized. The employee took the wood member to the table saw and set the fence to the correct size. The employee pressed down on the board to control it when his left little finger contacted the running blade, resulting in an amputation.
PERRYVILLE, MISSOURI—
Ready-Mix Concrete Incorporated
An employee was clearing a pipe along a culvert using a motorized plumbing machine. The end of the machine got tangled and stuck in long grass and other debris. The employee went to lift the end of the machine out of the grass and clear the blockage when his hand was pulled into the machine, resulting in a partial amputation and open fracture of his left distal phalanx.
ROANOKE, TEXAS—
Texas Building Supply
An employee was operating a router when it cut his right little finger, causing an amputation through the bone.
More severe injuries in CONNECTICUT
CHESHIRE, CONNECTICUT—
Heavy Weight Inc
An employee was checking on a machine outside of the building and removed a cover to clean out a blocked area. His hand was caught by a rotary valve in a dust collection machine. The employee's fingertip was amputated.
MERIDEN, CONNECTICUT—
Duro Bag
An employee was working to clean a glue roller with a scraper tool. The tool and the employee's left thumb were pinched between two rollers, resulting in a partial amputation.
HARTFORD, CONNECTICUT—
United Refrigeration Inc
An employee was re-arranging boxes of pipe insulation on a pallet. One of the boxes fell from the pallet and knocked over an upright empty cylinder. The cylinder fell and crushed the tip of the employee's right toe. The employee's toe required surgical amputation.
SOUTH WINDSOR, CONNECTICUT—
Michels Power, Inc.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
NORTH HAVEN, CONNECTICUT—
Parker-Hannifin Corporation
An employee was cutting extruded aluminum framing material using a horizontal band saw. She went to grab a rag in the machine when the rag contacted the blade and pulled her hand in toward the blade, resulting in a partial amputation of the right index finger.