IAM Acquisition, LLC dba Coregistics

During a tooling change on a piece of equipment, a maintenance mechanic had just removed a heat plate when another employee walked in his direction. He flipped the hot plate toward his chest to keep it from touching the other employee and suffered a pulled or torn muscle in the upper left arm and shoulder.

An employee was using an air compressor on a multi-wheel tire when the flange and the tire burst, causing the wheel's lock ring to strike the employee in the face. He sustained a laceration and facial fractures.

An employee was changing the connection to a compressed nitrogen tank when the system failed and exploded. One employee suffered a concussion and was hospitalized. The other employee sustained soft tissue injuries that did not require hospitalization.

An employee was putting air in a tire that was mounted on a customer's vehicle when the tire exploded, resulting in a left arm fracture that required hospitalization.

An employee was working in a kitchen when a spray can of oil exploded. Hot oil splashed onto the employee, burning their face and arms.

On October 24, 2023, at 12:00 PM, an employee was visually checking a gauge on the "U" controller when a pressure tank exploded. The employee was hospitalized with multiple facial fractures and required surgery.

An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.

An employee was using a powered miter saw to cut 2x4's. The saw blade hit something inside a board (possibly a hidden nail) and jumped, causing a laceration to the employee's left forearm. The employee was hospitalized with soft tissue and tendon injuries that required surgery.

A crane had been used to set a steel plate on a steel frame. An employee was trying to remove a clamp from the plate when the plate fell and crushed the tip of his left little finger. The employee sustained a fingertip amputation.

An employee was operating a scissor lift, raised to a height of about 15 feet, to inspect an overhead crane rail. The crane itself was being moved. Its hook swung into the scissor lift s arms, causing the lift to tip over onto its side, which in turn caused the lift and the employee to fall to the floor. The employee suffered injuries including broken ribs, spinal fractures, scapula fractures, and internal injuries.

A technician was operating a crane hoist to lift/remove a cylinder head from the main engine (port). The load was lifted at an angle, causing the cylinder head to get stuck on the cylinder head studs. When it became free from the studs, the cylinder head swung. It struck the technician and caught them against the cabinet door. This resulted in an amputation of their left index fingertip at the distal knuckle.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.