Grainger Industrial Supply

An employee was unloading a semi-truck trailer. Upon lifting a 30-pound box, the employee experienced a sharp pain in the side and back and was hospitalized for a back injury.

An employee was walking back to her workstation. A forklift reversed a short distance, then completed a U-turn and struck her, running over her lower extremities. She was hospitalized with a broken ankle.

An employee was training on a jockey truck. Upon stepping out of the truck, the employee was struck by a rubber tire gantry crane, resulting in amputations of the right leg above the knee and left leg below the knee.

An employee was standing at the rear of a double pallet jack. Another double jack approached, and the employee's lower leg was caught between the two pieces of equipment. He suffered a broken tibia and fibula.

An employee was unloading large material bags on a loading dock. A forklift tine pinned the employee's foot against a pallet, causing the employee to fall and suffer a broken ankle.

An employee was pushing a container when they were struck by a forklift. The employee sustained a left leg fracture.

An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.

An employee was using a powered miter saw to cut 2x4's. The saw blade hit something inside a board (possibly a hidden nail) and jumped, causing a laceration to the employee's left forearm. The employee was hospitalized with soft tissue and tendon injuries that required surgery.

A crane had been used to set a steel plate on a steel frame. An employee was trying to remove a clamp from the plate when the plate fell and crushed the tip of his left little finger. The employee sustained a fingertip amputation.

An employee was operating a scissor lift, raised to a height of about 15 feet, to inspect an overhead crane rail. The crane itself was being moved. Its hook swung into the scissor lift s arms, causing the lift to tip over onto its side, which in turn caused the lift and the employee to fall to the floor. The employee suffered injuries including broken ribs, spinal fractures, scapula fractures, and internal injuries.

A technician was operating a crane hoist to lift/remove a cylinder head from the main engine (port). The load was lifted at an angle, causing the cylinder head to get stuck on the cylinder head studs. When it became free from the studs, the cylinder head swung. It struck the technician and caught them against the cabinet door. This resulted in an amputation of their left index fingertip at the distal knuckle.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

An employee was inspecting a breaker box and turning on/off a circuit breaker when he was electrocuted.

An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.