Beeline Service

An employee was performing oversight for the welding of a pipeline launcher door on a construction project. Two welders were performing arc welding, one on the interior diameter of the pipeline launcher door, and the other on the outside diameter of the launcher door when a flash fire occurred. The injured employee sustained first- and second-degree burns to the face, neck, back, and hands.

While on a scissor lift, an employee was grinding a steel pipe. Sparks from the grinder ignited some nearby rags that had been used to apply coating treatments to the pipe. This fire subsequently ignited the employee's clothing. The employee sustained burns to approximately 46% of their body and was hospitalized.

An employee was working in an area where another company was also working. The other company's employees were using an electric hydraulic pump to remove the bolts of the frac valve. The wiring of the torque wrench and pump unit were then charred and a flash fire occurred. The employee sustained second-degree burns to their face and neck.

On October 17, 2023, an employee was at a sink while using a solvent to unclog a vacuum trap dip tube that contained solids from pinacolborane distillation. During this process, the sink caught on fire and the solvent bottle containing tert-butyl methyl ether fell into the burning sink. The employee attempted to remove the solvent bottle which also caught on fire and suffered burns to their neck and left hand.

An employee was under a railcar cleaning up dust with a vacuum hose. The hose caused a spark that caused a flash fire that ignited the employee's clothing. The employee sustained second- and third-degree burns over 83% of his body.

An employee was repairing the suspension of a semi-trailer. He was installing an air bag to the suspension when his left ring finger was crushed between the air bag and the suspension mounting beam. The employee was hospitalized.

An employee was refueling a pressure washer when it ignited and exploded. He suffered multiple third-degree burns to his chest and hands.

A mechanic had just finished a repair on a straight truck with a flatbed , which had been lifted using a bottle jack. As the employee was about to remove the jack, it failed. The truck shifted forward, dropped down, and struck the employee's chest. He suffered broken ribs and a broken shoulder.

An employee was performing diagnostic work on a vehicle engine. As the employee was leaning over the front of the vehicle, the engine was activated. A fuel leak had produced fumes around the engine, and the ignition spark ignited them. The employee suffered second-degree burns to both hands, both biceps, and the upper chest area.

An employee was hot patching a tire, which involves lighting a flammable liquid on fire to patch the tire. The flammable liquid contacted his arm, and he sustained burns to his arms and face.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.