YANKTON, SOUTH DAKOTA—
Hydro Extrusion USA, LLC
Struck by object falling from vehicle or machinery-other than vehicle part · Amputations
At a glance
Federal OSHA recorded a severe workplace injury at Hydro Extrusion USA, LLC, 2500 ALUMAX ROAD, YANKTON, SOUTH DAKOTA 57078 on — Amputations, affecting the foot (feet), n.e.c..
Final narrative
An employee was standing in front of a forklift carrying several 2,000-pound "logs" of aluminum. The logs were banded together; when the employee cut the banding so they could be unloaded, one of them rolled onto the employee's foot. The employee's steel safety toe collapsed, and the employee's toes and metatarsals were crushed. Part of the foot was medically amputated.
More severe injuries at Hydro Extrusion USA, LLC
MAGNOLIA, ARKANSAS—
Hydro Extrusion USA, LLC
An employee was adjusting rolls of vinyl that were on a pole set horizontally on a rack. As the employee was pushing the vinyl with his right hand, the right side of the pole dropped about 3 feet, pulling the left side of the pole downward at an angle. The employee's left ring finger became trapped/pinched between the pole holding the vinyl and the rack that was holding the pole. The employee's fingertip was amputated.
GAINESVILLE, GEORGIA—
Hydro Extrusion USA LLC
An employee was performing maintenance on a press puller and aligning the puller when it fell. The puller electrical panel struck their left upper back, resulting in fractures to their T12 and L1 vertebrae. The employee was hospitalized.
CRESSONA, PENNSYLVANIA—
Hydro Extrusion USA LLC
An employee was conducting preventative maintenance on an extrusion press and using an impact wrench to remove rivets on the shear cylinder. When the last rivet was removed, the stored energy in the cylinder released and dropped it onto the employee's hand. Their right thumb was caught between the cylinder and the casing of the rivet gun, resulting in crushing injuries. The employee sustained an amputation of the thumb without bone loss. The machine was locked out/tagged out at the time.
CRESSONA, PENNSYLVANIA—
Hydro Extrusion USA LLC
An employee was broaching a keyway in a bore sprocket with a manually operated powered cylinder hydraulic press. On pressing the broach through the initial phase of cutting, he used an extension rod to finish broaching and clear the broach from the part. While setting up the extension rod, he placed his left index finger on top of the extension rod. The press extended and crushed his finger, resulting in an amputation.
YANKTON, SOUTH DAKOTA—
Hydro Extrusion USA, LLC
While doing general labor, an employee developed signs of heat stress. After going home, later, he was hospitalized for dehydration and heat-related symptoms.
View Hydro Extrusion USA, LLC's full OSHA safety record →
Similar incidents · Same event type
HOUSTON, TEXAS—
Star Pipe Products LTD
An employee was using a crane. The hook slipped and a fitting fell onto a finger on the employee's left hand causing a fracture and laceration.
HOLLY SPRINGS, MISSISSIPPI—
KP Building Products, Inc.
An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.
BURLINGTON, NEW JERSEY—
BJ'S WHOLESALE CLUB, INC.
An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.
YOUNGSTOWN, OHIO—
International Steel and Counterweights LLC
An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.
KILLEEN, TEXAS—
Seneca Mechanical, LLC
An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.
More severe injuries in this industry (NAICS 423510)
PITTSBURGH, PENNSYLVANIA—
Triad Metals International
A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.
BEDFORD PARK, ILLINOIS—
Ryder System Inc.
An employee was on the deck of a trailer helping a customer unload tubes. The employee was working to place a cargo strap on the remaining tubes using a winch bar when it slipped off the tubing, causing him to lose his balance and fall headfirst onto the asphalt lot below. The employee suffered a contusion on his forehead, resulting in hospitalization.
SARASOTA, FLORIDA—
EASTERN METAL SUPPLY, INC.
An employee and a customer were unloading two rectangular tubes. The tubes were wrapped together. The plastic wrap was cut so that one tube could be picked up. As the employee was lifting the top tube, the other tube (still connected to the top tube) came down onto his hand and broke two of his fingers. He was hospitalized.
HOUSTON, TEXAS—
TEXAS PIPE AND SUPPLY COMPANY
An employee was assisting as a forklift got pipe from a pipe rack. The employee was on one of the forklift's forks as it was raised to the top of the rack, a height of about 15 feet. He fell to the ground and suffered a dislocated and fractured right elbow.
HAMILTON, OHIO—
United Performance Metals, LLC
On September 23, 2025, at approximately 7:43 p.m., an employee was using a knife to cut poly banding from a metal coil. The knife slipped, causing a laceration to the inside of their left arm at the elbow joint. The employee was hospitalized and required surgery to repair a damaged vein.
More severe injuries in SOUTH DAKOTA
RAPID CITY, SOUTH DAKOTA—
Simon Contractors of South Dakota, Inc.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
LEOLA, SOUTH DAKOTA—
Agtegra Cooperative
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
SIOUX FALLS, SOUTH DAKOTA—
Martin Brower Distribution Center
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
YANKTON, SOUTH DAKOTA—
Masonry Components, Inc.
A skid loader backed over an employee's leg, breaking it.
WILLOW LAKE, SOUTH DAKOTA—
Mayfield Truss, LLC
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.