105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Engineered Floors, LLC

Compressed or pinched by shifting objects or equipment · Amputations

Federal OSHA recorded a severe workplace injury at Engineered Floors, LLC, 100 Bentley Drive, CALHOUN, GEORGIA 30701 on — Amputations, affecting the fingertip(s).

An employee was emptying cardboard from a baler. As he was opening the baler door, he noticed it was stuck on the top gate. He lifted on the top gate to free the bottom door and the door swung open, smashing his right-hand fingers against the door latch. His right ring fingertip was amputated.

Hospitalized Amputation Fingertip(s) Banding, baling, strapping machinery

Engineered Floors, LLC

On October 25, 2024, an employee was operating a warper and had just completed a full beam. He doffed the completed beam onto the floor. The empty beam, which is stored overhead, came down as the employee's left hand was guiding the completed beam. This resulted in the amputation of the little finger.

ENGINEERED FLOORS, LLC

On April 29, 2024, an employee was replacing a wheel on a toolbox when it came down on his right middle finger, pinching it between the toolbox and the steel fork of a forklift. The fingertip was amputated.

ENGINEERED FLOORS, LLC

An employee was clearing out cones of yarn in a warehouse after a small fire the previous day. A case of yarn (destabilized by the fire and the water that had been used to suppress it) began to fall. As the employee turned to run away, cones of yarn fell out of the case and broke his right ankle.

ENGINEERED FLOORS, LLC

An employee was operating a forklift when the vehicle struck a support beam. The employee sustained a contusion to his left rib.

Engineered Floors, LLC.

On September 18, 2021, at approximately 11:08 PM, a maintenance employee was repairing a heatset tunnel exit roller. The rubberized coating on the exit roller ruptured, blowing pressurized steam and hot water onto the employee. The employee was hospitalized with second and third degree burns to the left arm, abdomen, and back.

View Engineered Floors, LLC's full OSHA safety record →

TForce Freight

An employee was operating a forklift and unloading a truck. After the truck was unloaded, the employee got off the forklift and proceeded to adjust the dock plate with a hook tool. The dock plate slipped and the employee went to adjust the plate with their hand when their left middle finger got caught. Their finger was amputated above the first joint.

Liveo Research, Inc.

An employee was rotating a carbide granulator blade when his finger was caught between the blade and a stationary part of the machine. The employee's right middle finger was partially amputated and they suffered an avulsion to the right ring fingertip.

Best Pump and Flow

An employee was using a CNC metal lathe machine in manual mode to check that the thread blocking tool made contact with the jaws. As the employee was manually spinning the spindle, his index fingertip was crushed between the spindle's jaws and the grooving insert, resulting in a fingertip amputation.

FORD MOTOR COMPANY

During a material handling operation, an employee's fingertip was caught under an air conditioning unit as the unit was lowered onto a cart. The employee's fingertip was amputated.

Lasseter Tractor Company. Inc.

An employee was removing a bolt from a tractor hub when their right index finger was caught between the hub and the frame. The employee's fingertip was crushed and the employee was hospitalized.

Tred-MOR Sponge Cushion Inc

After replacing an air cylinder, an employee was under a conveyor belt to move it back to center. His left arm was pulled into the conveyor. The employee was hospitalized with a fractured arm.

Bally Ribbon Mills Inc.

An employee was on a roof, looking for the source of a leak. A power pump sent condensate up a vent pipe, and steam and boiling water discharged onto the employee. The employee suffered burns to their back and shoulder.

Engineered Floors, LLC

On October 25, 2024, an employee was operating a warper and had just completed a full beam. He doffed the completed beam onto the floor. The empty beam, which is stored overhead, came down as the employee's left hand was guiding the completed beam. This resulted in the amputation of the little finger.

FY Holdings

An employee's hand and arm were caught in the rollers on a carding machine used for yarn manufacturing and were fractured.

ARYLESSENCE FOUNDATION, INC.

An employee was in a warehouse moving a portable generator and pinched his right middle finger between two metal hinges, resulting in amputation at the third joint.

GS II Building Products, Inc.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

US Battery Manufacturing Company, Inc

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

Alfa Insurance

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

EMORY UNIVERSITY HOSPITAL

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

Bull Moose Tube

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.