Caught, entangled in running powered equipment normal operation · Amputations involving bone loss
At a glance
Federal OSHA recorded a severe workplace injury
at Engineered Floors, LLC, 3829 S Dug Gap Rd, DALTON, GEORGIA 30721
on — Amputations involving bone loss, affecting the Other finger(s) n.e.c..
Final narrative
On October 25, 2024, an employee was operating a warper and had just completed a full beam. He doffed the completed beam onto the floor. The empty beam, which is stored overhead, came down as the employee's left hand was guiding the completed beam. This resulted in the amputation of the little finger.
HospitalizedAmputation Other finger(s) n.e.c. Metal, woodworking, and special material machinery unspecified
On April 29, 2024, an employee was replacing a wheel on a toolbox when it came down on his right middle finger, pinching it between the toolbox and the steel fork of a forklift. The fingertip was amputated.
An employee was clearing out cones of yarn in a warehouse after a small fire the previous day. A case of yarn (destabilized by the fire and the water that had been used to suppress it) began to fall. As the employee turned to run away, cones of yarn fell out of the case and broke his right ankle.
On September 18, 2021, at approximately 11:08 PM, a maintenance employee was repairing a heatset tunnel exit roller. The rubberized coating on the exit roller ruptured, blowing pressurized steam and hot water onto the employee. The employee was hospitalized with second and third degree burns to the left arm, abdomen, and back.
An employee was looking for defects in a carpet while standing on the floor between a catwalk and the exit roller of a tufting machine. He stepped backward and tripped on the edge of the catwalk, grabbing onto the exit roller of the machine with his left hand in order to catch himself. While doing so, his left index finger went into the keyway hole on the rotating exit roller, which caused his left index finger to be lacerated.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was working on a production line. The employee went to retrieve parts that came out of the parts holder, and their left hand became caught between a chain and a sprocket. Three fingers on the hand were amputated.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a pad printer. The employee's finger was caught in the printer and they suffered a fingertip amputation. The part of the printer that caught the employee's finger was unguarded at the time.
More severe injuries in this industry (NAICS 313110)
After replacing an air cylinder, an employee was under a conveyor belt to move it back to center. His left arm was pulled into the conveyor. The employee was hospitalized with a fractured arm.
An employee was on a roof, looking for the source of a leak. A power pump sent condensate up a vent pipe, and steam and boiling water discharged onto the employee. The employee suffered burns to their back and shoulder.
An employee was in a warehouse moving a portable generator and pinched his right middle finger between two metal hinges, resulting in amputation at the third joint.
An employee was pulling a piece of plastic brick that had become stuck on a pallet. The employee fell backward and suffered a broken hip and broken right finger.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.