Ignition of clothing from controlled heat source · Second degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Alpha Shredding Group, Inc, 301 Enterprise Avenue, TRENTON, NEW JERSEY 08638
on — Second degree heat (thermal) burns, affecting the multiple body parts, unspecified.
Final narrative
An employee was cutting a catalytic converter with a torch. A spark from the torch set the employee's clothing on fire. The employee suffered a second-degree burn to the right side of the body.
HospitalizedMultiple body parts, unspecifiedClothing, unspecified
An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.
An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.
An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.
An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.
More severe injuries in this industry (NAICS 423930)
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was checking on a machine outside of the building and removed a cover to clean out a blocked area. His hand was caught by a rotary valve in a dust collection machine. The employee's fingertip was amputated.
A shear operator's hand and fingers were caught in a machine's point of operation. The operator's right index finger was crushed and was partially medically amputated.
An employee was operating a forklift. He parked on a ramp and got off the forklift to retrieve material, at which point the forklift rolled backward and ran over his leg. The leg was broken and he was hospitalized, requiring surgery.
An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.
An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.
An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.