Caught in running equipment or machinery during maintenance, cleaning · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at IMI Norgren Inc, 25150 South Governors Highway, UNIVERSITY PARK, ILLINOIS 60484
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was working on a small-bore lathe. He put an extension on the lathe. Then, noticing that the tube and the lathe seemed to be off-center, he reached in and tried to correct the issue. The tube caught his cut-resistant glove, pulled in his left index finger, and amputated part of it. The machine was unguarded at the time.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333995)
An employee was working in the shipping/receiving area on a packing paper dispenser that was jammed. When the paper came free, the blade pulled the paper in and pulled the employee's hand in too, amputating about a quarter of the right middle fingernail and the top of the finger.
On June 27, 2025, at approximately 7:00 PM, an employee was operating a cell that presses rings on a cylinder and welds the rings on. The cylinder was moving between the welding station and the press station when it fell off the holder. The employee went to place the cylinder back on the holder when the cell cycled and the compression holder crushed their right hand. The employee's middle, ring, and little fingers were crushed.
An employee was working on a hydraulic cylinder at his work table. While he was removing a bleeder plug to reduce the pressure, the 3/8-inch steel plug was pushed out by oil pressure. The plug impacted his wrist, causing an abrasion where hydraulic oil went into his arm. The employee was hospitalized.
An employee was pulling a steel cart backward when his left ring finger was crushed between the cart and another steel cart, resulting in amputation of the fingertip.
An employee was using a hydraulic press to repair a hydraulic tool that was stuck in the open position. Upon adding downward pressure from the hydraulic press, the tool's hydraulic quick coupler broke and released the ball bearing inside the coupler. The ball bearing struck the employee in the abdomen, resulting in lacerations and abrasions. The ball bearing also penetrated the employee's abdomen.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.