105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

W&W AFCO Steel, LLC

Ignition of clothing from controlled heat source · Heat (thermal) burns, unspecified

Federal OSHA recorded a severe workplace injury at W&W AFCO Steel, LLC, 1085 Parker St., MONTGOMERY, ALABAMA 36108 on — Heat (thermal) burns, unspecified, affecting the upper and lower limb(s).

An employee was setting up a CNC burn table. He was lighting the heads with a striker when his pant leg caught fire, causing burns to his thigh and hand. The employee was hospitalized.

Hospitalized Upper and lower limb(s) Blouses, shirts, dresses, trousers, skirts

W&W-AFCO Steel, LLC

An employee tripped over a piece of angle iron that was on the floor. He landed on his left knee and the knee was fractured.

W & W / AFCO Steel LLC

An employee was sandblasting metal and dropped the sandblasting gun, causing sand to strike their left triceps.

W & W - AFCO Steel LLC

An employee was using an overhead bridge crane to position a piece of steel on a band saw. The employee went to stabilize the piece when the hydraulic clamp closed on the employee's little finger. The finger was surgically amputated at the first knuckle.

W&W-AFCO Steel, LLC

An employee was sitting on a forklift while on break in the paint shop. An unknown person/assailant walked into the shop and shot the employee in the head.

W&W AFCO Steel, LLC

An employee was using an overhead crane to dump blasting media in a 55-gallon drum into a dumpster. The chain slipped and a pinch point was created between it and the drum. The employee's thumb was caught, resulting in a right thumb tip amputation.

View W&W AFCO Steel, LLC's full OSHA safety record →

Falls Manufacturing Company/a U-Haul Co.

An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.

Flint Ag & Turf

An employee was using a small propane heater when they sustained third-degree burns to the left buttock and second-degree burns to the back and neck.

Novae, LLC.

An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.

Pik Rite Inc.

An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.

DC Power Tong, LLC

An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.

Cashless Tolling Constructors

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

Anderson Columbia Co., Inc.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

FLATIRON CONSTRUCTION CORP.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

Warner Brothers, LLC

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

Don Martin Corporation

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

Sysco Gulf Coast, LLC

An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.

Norflex, Inc.

An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.

Ampler Pizza II LLC

An employee was shot in the leg with a pistol during an altercation with two people who had entered the store without permission.

Birdsong Corporation

An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.

Pilgrims

An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.