FOND DU LAC, WISCONSIN—
Alliance Manufacturing, Inc.
Contact with objects and equipment, unspecified · Fractures
At a glance
Federal OSHA recorded a severe workplace injury at Alliance Manufacturing, Inc., 1368 Capital Drive, FOND DU LAC, WISCONSIN 54937 on — Fractures, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was in a paint booth, lifting something above his head. The object slipped and the employee's left index finger became caught in a sliding channel. The finger was broken between the knuckle and the first joint.
More severe injuries at Alliance Manufacturing, Inc.
FOND DU LAC, WISCONSIN—
Alliance Manufacturing, Inc.
An employee was using a handheld air velocity tester to check the air velocity of a rotary indexing machine. The inner turntable and baffles rotated, contacting the employee's left hand. The end of a finger was degloved to the second knuckle resulting in hospitalization.
View Alliance Manufacturing, Inc.'s full OSHA safety record →
Similar incidents · Same event type
MCCAMEY, TEXAS—
NorAm Drilling Company
An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.
CHICAGO, ILLINOIS—
Stalworth Underground LLC
Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.
ETHEL, MISSISSIPPI—
National Park Service U.S. Department of the Interior
Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.
ANDREWS, TEXAS—
HT Energy LLC
An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.
BELLE GLADE, FLORIDA—
TKM BENGARD FARMS, LLC
An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.
More severe injuries in this industry (NAICS 423830)
MIDLAND, TEXAS—
TRC Services of Texas INC
An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.
DEER PARK, TEXAS—
Onpoint Industrial Services Hiring Center
An employee was using a powered miter saw to cut 2x4's. The saw blade hit something inside a board (possibly a hidden nail) and jumped, causing a laceration to the employee's left forearm. The employee was hospitalized with soft tissue and tendon injuries that required surgery.
TULSA, OKLAHOMA—
S&R Compression, LLC
A crane had been used to set a steel plate on a steel frame. An employee was trying to remove a clamp from the plate when the plate fell and crushed the tip of his left little finger. The employee sustained a fingertip amputation.
GIRARD, OHIO—
Morgan Engineering Systems, Inc
An employee was operating a scissor lift, raised to a height of about 15 feet, to inspect an overhead crane rail. The crane itself was being moved. Its hook swung into the scissor lift s arms, causing the lift to tip over onto its side, which in turn caused the lift and the employee to fall to the floor. The employee suffered injuries including broken ribs, spinal fractures, scapula fractures, and internal injuries.
NORTH CHARLESTON, SOUTH CAROLINA—
Fairbanks Morse, LLC
A technician was operating a crane hoist to lift/remove a cylinder head from the main engine (port). The load was lifted at an angle, causing the cylinder head to get stuck on the cylinder head studs. When it became free from the studs, the cylinder head swung. It struck the technician and caught them against the cabinet door. This resulted in an amputation of their left index fingertip at the distal knuckle.
More severe injuries in WISCONSIN
MADISON, WISCONSIN—
RG Professional Carpenter, Inc.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
FRANKLIN, WISCONSIN—
General Thermodynamics, Inc.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
SAINT CLOUD, WISCONSIN—
Sargento Foods Inc
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
HIXTON, WISCONSIN—
Asher Enterprises, Inc.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
VERONA, WISCONSIN—
Consolidated Electrical Distributors Inc.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.