Direct exposure to electricity, unspecified · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at C DAVIS ELECTRIC CO., INC., 347 Don Shula Dr., MIAMI GARDENS, FLORIDA 33056
on — Electrical burns, unspecified, affecting the nonclassifiable.
Final narrative
An employee was performing an electrical job on a panel when an arc flash occurred, resulting in burns that required hospitalization.
An employee was on a ladder installing a light fixture when he received an electrical shock, causing him to fall off the ladder to the ground. He suffered a back injury.
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 811219)
A mechanic was replacing the airbag suspension on the front axle of a utility trailer. The airbag blew out, causing an injury to the mechanic's left foot that required hospitalization and surgery.
Employees were installing a truck scale and lowering a module when the injured employee's right ring finger was caught between the module and a side rail. The employee sustained an amputation of the finger to the first knuckle.
An employee was using a 40-ton press to remold a steel part when a steel plug guide shot out from the press and struck the employee in their midsection, causing three broken ribs and a hematoma.
An employee was servicing an air handler at ground level when their left hand contacted a rotating belt. The employee sustained a fingertip amputation.
An employee was calibrating a 100-ton transfer rail using a forklift attachment referred to as an evener which was a metal lifting device. The employee was holding the evener up so that another employee could slide the forklift tines under the evener bar and lift the calibration blocks. During this process one of the forklift tines pinched the employee s right ring finger between the tine and the evener bar resulting in a fingertip amputation.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.