Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Builders First Source, 3703 Old Oakwood Road, OAKWOOD, GEORGIA 30566
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was measuring a block on a pedal-operated upcut saw equipped with a 10 or 12 inch circular blade. As he was taking a measurement, the blade contacted his left hand, resulting in amputations of three fingers.
Employees were stacking two different types of trusses in a yard. One employee was lifting one end of a truss with a forklift while another inserted a spreader block. The load shifted, and the second employee's left ring finger was pinched between the block and the trusses. The finger was amputated.
An employee had been installing door and inside trim at a location. The employee was cutting lumber with a chop saw and amputated his left middle and index fingers.
An employee was behind a truck, preparing to dump one of two pallets of lumber from the truck's dump body (which had been raised so the lumber could be unloaded). The other pallet slid off the truck and struck the employee's lower leg, breaking it.
An employee was unloading lumber from a railcar. Railcars have ladders welded to each side for employees to enter/exit. The employee was climbing down one of the railcar ladders and slipped and fell between 6 and 8 feet to the ground. The employee suffered a fractured back, dislocated shoulder, and laceration to the top of the head.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 321214)
An employee was spreading out wood on the live feed table. As he was operating the automatic feed saw, and the wood went in crooked and he went to straighten it. His left middle fingertip was crushed between the wood and the computer monitor. The employee's fingertip was amputated without loss of bone.
An employee was working on a conveyor belt in the chipper room that was not functioning. While inspecting the uncovered gearbox, the conveyor system started. The employee sustained an amputation to their right little finger. The conveyor system was not locked out at the time.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.
An employee was placing trusses on conveyor rollers to be stacked. The rollers could not roll the trusses, so the employee pulled the trusses onto the rollers. One of the spinning rollers caught their hand, resulting in three fingertip amputations.
An employee reached down to pick up a box next to a roller conveyor. His gloved left hand was caught in the chain and pulled into the sprocket. Three fingers were injured: the middle and index fingers were cut to the bone, and the ring finger was amputated at the nail.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.