Struck by object or equipment, unspecified · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Delta Steel, Inc, 7355 ROUND HOUSE LANE, HOUSTON, TEXAS 77078
on — Soreness, pain, hurt-nonspecified injury, affecting the arm(s), unspecified.
Final narrative
An employee was standing next to a transfer table which lifts tubing into the area to be processed and cut by the horizontal band saw. A 48-foot-long piece of 6-by-6 tube that was on the transfer table struck his right arm, resulting in an injury.
An employee was moving a rectangular stock to create a dunnage platform. While manually sliding the stock, his little finger got caught between two pieces of steel tube, resulting in a partial fingertip amputation.
An overhead crane was being used to stack 4-by-4-by-20-foot steel beams on an existing pile of beams. An employee was walking through the area when a stack of about 20 beams from the pile collapsed and struck the employee's legs, breaking both of them.
An employee was checking the function of newly installed actuators when they were struck by a pressurized release pipe. The employee suffered fractures to the orbital socket and shoulder, requiring hospitalization.
An employee was completing a service call and looking at a water pump when the pump cover plate struck their forehead. The employee sustained a forehead laceration and fracture requiring hospitalization.
An employee was removing chains from a steel tube. A sorting hook attachment was caught on the staging area cross member. When he raised the chains, the sorting hook snapped back and struck the employee's face causing a fractured jaw.
An employee was in the sawmill basement using a push broom and shovel to clean wood chips and sawdust. The employee's right arm was struck by a wooden board between the wrist and elbow, resulting in a fracture.
More severe injuries in this industry (NAICS 423510)
A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.
An employee was on the deck of a trailer helping a customer unload tubes. The employee was working to place a cargo strap on the remaining tubes using a winch bar when it slipped off the tubing, causing him to lose his balance and fall headfirst onto the asphalt lot below. The employee suffered a contusion on his forehead, resulting in hospitalization.
An employee and a customer were unloading two rectangular tubes. The tubes were wrapped together. The plastic wrap was cut so that one tube could be picked up. As the employee was lifting the top tube, the other tube (still connected to the top tube) came down onto his hand and broke two of his fingers. He was hospitalized.
An employee was assisting as a forklift got pipe from a pipe rack. The employee was on one of the forklift's forks as it was raised to the top of the rack, a height of about 15 feet. He fell to the ground and suffered a dislocated and fractured right elbow.
On September 23, 2025, at approximately 7:43 p.m., an employee was using a knife to cut poly banding from a metal coil. The knife slipped, causing a laceration to the inside of their left arm at the elbow joint. The employee was hospitalized and required surgery to repair a damaged vein.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.