SSA Atlantic, LLC

An employee was unloading a ship when he was struck by a forklift, resulting in a broken right ankle.

Four employees were rigging a truck to be lifted off a ship by a crane. The crane began lifting the truck, causing it to move and knock one of the employees into a nearby shipping container. He suffered multiple injuries to the upper torso.

An employee was scanning barcodes on vehicles and going through the manifest as a checker. They went to the rear of a vehicle to scan a barcode when the vehicle behind them rolled forward into them. The employee was punctured by a removeable latching pin on the front of the vehicle and sustained a laceration above the knee. They were hospitalized.

An employee was standing next to a jockey truck. A pickup truck crossed a marked RTG lane and struck the employee, who suffered a fractured skull, broken vertebrae in the back, and a dislocated left shoulder.

A truck driver had parked a truck, carrying a container, under a crane. The crane picked up the trailer and took the truck with it, lifting the truck about 10 feet. When the crane lowered the truck, equipment inside the cabin injured the employee's neck, lower back, and right arm. The employee was hospitalized.

On 11/22/2023, at 8:35 AM, an employee was stepping onto a barge when they slipped on a wet surface and fell on their knee. The employee sustained a torn ligament in their knee requiring hospitalization and surgery.

After moving a barge lid, an employee was walking down the stairs on the barge when they slipped and fell approximately 15 to 20 feet, reuslting in a head injury.

An employee was using an excavator on a barge to scoop and remove fertilizer product stored in the cargo area. As the employee was transporting the skid-steer by chains and hoisting equipment from the dock to the barge, the employee fell approximately 10 feet off the skid-steer bucket to the cargo hold area below. The employee suffered a concussion.

Swingmen were performing discharge of an iron ore vessel. The discharge process consists of gathering remaining product into the center of the hold to facilitate removal by crane. At approximately 11:45 PM, a swingman was descending a ladder into a hold when he lost his footing and fell approximately 10-15 feet to the deck of the hold. The employee sustained fractures to their back and left leg.

An employee was on a bulk carrier ship. While removing lashing from wind turbine components, the employee lost balance and fell approximately 6 - 7 feet from a hatch to the deck of the ship. The employee was hospitalized with a head injury, and a fractured wrist, and required surgery.

While preparing to install a new spool piece for a vapor and spent sulfuric acid line, an employee was working to ensure there was no residual product or pressure in the line before removing the 6-inch hose. The valve was cracked, and some spent acid still in the line sprayed out. The employee was standing off to the side and at a distance, but was still contacted by the hot acid, resulting in corrosive and thermal burns to their upper torso and mid-thighs of both legs.

An employee was driving a utility tractor rig when it struck the rear trailer of another utility tractor rig, which was traveling in the opposite direction. The glancing impact caused damage to the cab, and he sustained a laceration on right side of his face, a cervical fracture, two fractured left ribs, and a pelvic fracture. The employee was hospitalized.

The injured employee was standing by the controls for the electric spud system on the barge, preparing to raise the spuds. Meanwhile, an excavator was moving a mat on the deck. As the excavator swung from port to starboard, it's counterweight struck the injured employee s shoulder, causing them to lose balance and fall against the spud controls. The employee sustained bruises and contusions to their right shoulder and chest.

An employee was standing on the outside edge of a hopper barge while watching a skid steer push ore for an excavator (with a clamshell bucket) to unload. The excavator was on a work barge. The bucket of the excavator struck the employee and caused a near-amputation of their right arm and fractures of the ulna and radius of the left arm. The right arm required surgery.

An employee was inspecting a conveyor to see why it was not running. The employee entered the the conveyor motor area, tripped on a piece of angle iron welded to the floor, and fell. The employee sustained a fractured orbital bone.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.