Good Energy Solutions, Inc.

An employee was attempting to lift a rechargeable energy storage system weighing approximately 250 pounds onto a wall-mounted bracket. The employee was on the left side of the bracket with his hands under the storage system when it fell and crushed his left little finger, resulting in injuries that required surgery.

An employee was transitioning from a ladder onto a roof when the ladder slipped and they fell approximately 20 feet to the ground. The employee was hospitalized with fractures to their pelvis and heel.

An employee was tearing down shingles when they fell approximately 18 feet from a roof to the ground, sustaining a broken ankle.

An employee was climbing a ladder to bring material onto a roof. The ladder slid and the employee fell 16 feet to the ground, resulting in a broken knee.

An employee was performing an inspection of a bridge crane while working from a 19-foot scissor lift. The employee was going to use a pendant to move the crane to access a different portion of the crane for visual inspection. The scissor lift guard rails were below the girder of the crane to avoid contact. The tow arm for the crane collectors contacted the guardrail of the scissor lift and caused it to tip over. The employee stayed inside the scissor lift basket as he fell to the floor. The employee sustained fractures to the right arm and hip.

An employee was on a forklift that was elevated approximately 20 feet and was auditing inventory. The forklift malfunctioned and the employee fell down to the surface below, causing them to sustain multiple fractures.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.

An employee was changing fuel filters on a front-end loader. When he descended the access steps of the engine bay, he misstepped and fell approximately 3 feet to the concrete surface below. The employee sustained a fractured left hip.

An employee was walking in the warehouse when their foot was struck by the forks of an unloaded forklift that was passing by. The employee's foot was fractured.

An employee was climbing down an extension ladder from a residential roof. The ladder collapsed under his foot, and he fell backward onto the grass. He suffered a sprained neck, a fractured scapula, and fractures to his T7 and T12 vertebrae.

An employee was working to straighten a solar panel by reaching into the unguarded rotating section of the conveyor when their right thumb got caught in the conveyor, resulting in amputation of their right thumb.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.