Fiber-Line LLC

An employee was drying and finishing vehicles when a vehicle door closed on their left middle fingertip and amputated it.

An employee was climbing down from a tractor trailer bed when they lost their footing and grabbed onto the roll-up door to stop the fall. The roll-up door then fell onto the employee's hand, resulting in a hand fracture that required surgery.

An employee was attempting to remove a tarp from a flatbed trailer when the trailer handle struck the employee in the chest, resulting in two broken ribs and a punctured lung.

An employee was near a backhoe while the operator was getting a broom. The broom handle struck the lever that actuates the swing of the backhoe bucket. The bucket then struck the injured employee, pinning him to the outrigger. The employee suffered crush injuries to the chest.

The injured employee was being trained on loading trucks in the load out bay. The injured employee and his supervisor climbed the stairs that run parallel to the truck and trailer, walked to the upper platform used for observation and sample taking, and saw that the lid of the grain trailer was closed. The employees began working to open the lid which appeared to be stuck due to cold weather. The injured employee pulled on one of the pivot arms that connect the lid to the main body of the trailer. As the lid began to open, the employee s right hand slipped down on the pivot arm and his index finger was caught between the pivot arm and the base of the pivot arm. The employee s right index finger was fractured and three nerves were severed. The employee was hospitalized.

An employee opened a screen changer when pressurized steam and resin blew out from the changer, resulting in a fourth-degree burn to their left arm.

A temporary employee cut back-wrapped material on an extrusion line. His left hand was caught in the material as he tried to clear it. As the material continued to rotate, the employee's left ring finger was severed, resulting in a partial amputation.

An employee was using a plastic pipe to clear a jam in the shredding equipment. The pipe got stuck in the shredder and went into a vertical position, crushing the employee's left ring finger between the pipe and the top of the shredder shroud. The employee sustained a fingertip amputation.

An employee was operating a stand-up forklift to move a pallet of product that was sitting on the floor in an aisle of the finishing warehouse next to metal racking. The forklift cab went under the middle shelf and his torso became caught between the metal shelf (at his back) and the forklift steering control stick (at his front). He was hospitalized with possible fractured ribs.

An employee was starting to collect edge trim when their right middle and ring fingers came into contact with a shear slitter blade. Half of the ring finger was nearly amputated, and half of the middle finger was amputated.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.