Faddis Concrete Products

An employee and a co-worker were preparing to remove a load of mesh from a flatbed. After releasing the ratchet strap that was being used to secure the mesh, the tension on the strap caused the mesh to shift and fall toward the employee. The employee was pushed into a panel behind him, resulting in a fractured left index finger, C5 and C7 spinal fractures, and possible nerve damage.

An employee was scraping concrete from a form. As he tried to lift a panel with an overhead crane, his finger was caught between the panel and the chain of the lift. The finger was crushed and the fingertip was fractured. The fingertip was later medically amputated.

A temporary employee utilized an overhead crane to move a concrete panel from one area to another. The panel started moving towards a post. The employee put his hand on the concrete panel to stop it before hitting the post, but his left hand was caught between the panel and the post. The employee sustained a crushing injury to the left hand and was hospitalized for surgery.

Three concrete panels were placed on dunnage, approximately 6" off the ground in the batch end area of the plant. The dunnage was perpendicular to the panels and approximately 3 feet from each end of the panel. These panels were spaced about 3 to 4 feet apart and were free standing on the dunnage. At 6:40 p.m., an employee was picking up foam pieces in the same area and placing them into a 5-gallon bucket. He bent down to pick up an item about midway down the panel when the second panel from the bay door started to tip as the employee stood up. The panel came down and hit the employee about waist level (front side) and pushed him back into the third panel (closest to bay door). Both panels fell towards the south end of the building and the second panel ended up on top of the employee's right leg. The dunnage acted as a buffer to keep his leg from being fully crushed. He was hospitalized with a broken right tibia and torn right knee ligaments.

An employee was standing on a conveyor (approximately 2 feet to 3 feet above the ground) to cut and dismantle it when the conveyor collapsed. The employee fell and hit the ground/steel conveyor frame, suffering a fractured hip and wrist.

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was patching precast concrete. He fell from a concrete wall support to the ground due to wind. He was hospitalized with fractures to his left ankle and right knee.

An employee was opening a precast concrete form and rolled his ankle. The employee required surgery on his ankle.

A driver slipped and fell to the ground while exiting his truck. He sustained a lacerated spleen.

An employee was cutting wood on a table saw when the wood got jammed. While clearing the jam, the wood moved forward and his left index and middle fingertips were amputated.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.