Struck by rolling, sliding, or shifting objects non-running · Dislocations
At a glance
Federal OSHA recorded a severe workplace injury
at Bolton Ford, L.L.C. Service, 1500 East College Street, LAKE CHARLES, LOUISIANA 70607
on — Dislocations, affecting the Hip joint(s).
Final narrative
An employee was pushing a car out of a service bay. The car kept rolling and the employee tried to stop the vehicle from rolling into a parked vehicle. The car struck the employee and their leg was caught between the two vehicles, resulting in a hip dislocation and bruising. The employee was hospitalized.
An employee was using his left hand to push an axle down the line on a raised track work area while holding the remaining axle back with his right hand. A finger on his right hand was caught between the rail and the dust guard of the axle, resulting in a fracture and a laceration.
An employee was moving metal out of a cart. He had removed one piece and was working to move another when the metal shifted. His right ring finger was crushed between the two pieces, and he suffered a partial amputation to the finger pad at the tip.
A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.
Employees were replacing a 24" pig trap door. A strap was shackled on the pig trap door and connected to a forklift. Welders began to cut the door off. An employee was holding onto the door when the cut was finished. The door shifted and caught his fingers, resulting in a hand injury and amputation.
An employee used a crane to set down a bar. The bar measured 9 inches by 16 feet. The strap got stuck under the bar, and the employee asked another employee to jog the roll. The bar rolled and pinched the injured employee's left hand, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 811111)
An employee was repairing the suspension of a semi-trailer. He was installing an air bag to the suspension when his left ring finger was crushed between the air bag and the suspension mounting beam. The employee was hospitalized.
A mechanic had just finished a repair on a straight truck with a flatbed , which had been lifted using a bottle jack. As the employee was about to remove the jack, it failed. The truck shifted forward, dropped down, and struck the employee's chest. He suffered broken ribs and a broken shoulder.
An employee was performing diagnostic work on a vehicle engine. As the employee was leaning over the front of the vehicle, the engine was activated. A fuel leak had produced fumes around the engine, and the ignition spark ignited them. The employee suffered second-degree burns to both hands, both biceps, and the upper chest area.
An employee was hot patching a tire, which involves lighting a flammable liquid on fire to patch the tire. The flammable liquid contacted his arm, and he sustained burns to his arms and face.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.