105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

PAR Electrical Contractors, LLC

Struck by other falling object n.e.c. · Fractures

Federal OSHA recorded a severe workplace injury at PAR Electrical Contractors, LLC, 3215 W Pawnee Street, WICHITA, KANSAS 67213 on — Fractures , affecting the Leg(s) unspecified.

A work crew was removing a wire reel from a digger derrick. A reel fell and struck an employee's left leg, fracturing it.

Hospitalized Leg(s) unspecified Reels, rolls, spools, coils

PAR Electrical Contractors, LLC

Three employees were responding to a power outage caused by a recent storm. While climbing a utility pole, an employee contacted an electrical component with his left hand, thumb, and index finger, resulting in an electrical shock and probable exposure to an arc flash. The injured employee lost consciousness and was found hanging upside down in his rope harness, requiring resuscitation and resulting in hospitalization.

PAR Electrical Contractors, LLC

An employee was replacing switches on 23-kilovolt circuits at an electrical substation. While trying to take measurements with a metallic tape measure, the employee was shocked and burned.

View PAR Electrical Contractors, LLC's full OSHA safety record →

RG Professional Carpenter, Inc.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

Rae Corporation

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

Red Dot Corporation

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

Simon Contractors of South Dakota, Inc.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

RJV Construction

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

Kasparian Underground LLC

An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.

Viking Utility Construction

An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.

Henkels & Mc Coy

An employee was working to move a telephone pole when the pole rolled, causing injury to their hip.

Standard Utility Construction, Inc.

An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.

Michels Power, Inc.

An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.

Omya Inc.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

John Deere Coffeyville Works

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

Haven Steel Products Inc

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Vestas-American Wind Tech

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

Alliance Ag and Grain LLC

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.