Contact with hot objects or substances · Thermal burns first degree
At a glance
Federal OSHA recorded a severe workplace injury
at KL Dawson, Angel Road, FAIRMOUNT, GEORGIA 30139
on — Thermal burns first degree, affecting the Trunk and other upper extremities.
Final narrative
An employee had been skidding wood. They opened the radiator to let some pressure out and hot radiator fluid exploded all over him, causing second-degree burns to his right hand, arm, side, and back. The employee was hospitalized.
Hospitalized Trunk and other upper extremities Antifreeze
An employee pulled out a bucket of hot oil from under the fryer. The employee then stood on the table to clean the back wall. He stepped down into the bucket of hot oil, resulting in third-degree burns to his left leg.
An employee was performing maintenance under a kettle. When he removed a tri-clamp on a transfer line, the hot fat and broth material in the kettle poured out onto his arm. The employee was hospitalized with burns.
After completing a run with an oil distributor truck, an employee was working to return (suction) the hot oil to the tank of the truck. When the employee opened one of the valves, hot oil (approximately 385 degrees) sprayed their face, resulting in first-, second-, and third-degree burns.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was using a water hose to clean debris out of the outfeed of a log conditioning vat. Water began entering the vat from the adjoining vat through a void in the separation wall at the infeed of the vats. As the employee was exiting the vat he had been working in using the access opening at the outfeed, hot water exiting the access opening entered the top of his protective hip wader. It pooled at the bottom of the wader and burned his left foot and ankle.
More severe injuries in this industry (NAICS 113310)
An employee was working with a group of tree trimmers to trim a tree that was approximately 66 feet high and 28 inches in diameter. When the tree fell, it struck the employee. He was hospitalized with multiple fractures to the left side of his body, including his head.
On July 18, 2025, at approximately 1:09 PM, an employee was moving a trailer-mounted de-limber. He set his ground saw on the de-limber trailer and then got off the loader and stood to the side of the ground saw. A grapple skidder was raising the trailer slightly so he could throw the chain under the trailer to secure the ground saw. He then turned around and the ground saw slid off the trailer and struck his back. The employee was hospitalized with four fractured vertebrae.
On June 23, 2025, an employee was assisting with a tire replacement. As the employee was returning with tools, two co-workers were positioning the tire on the hub. The tire released pressure, causing a piece of the split rim to strike the employee. They were hospitalized with a fractured left ankle and pelvis.
An employee was cutting a tree. As they were walking away, part of the tree broke off and struck the employee. The employee sustained five broken ribs and a punctured lung.
An employee was climbing down a tree after setting a rope to allow the tree to be removed. A knot at the end of his climbing system failed and he fell from the tree, landing about 35 feet below. He suffered fractures to the pelvis and spinal cord and was hospitalized.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.