Keystone Consolidated Industries, Inc.

An employee was working to close a furnace door. The hydraulic mechanism that opens and closes the furnace door was non-operational and had been disconnected to allow the furnace door to be opened manually. As the employee was releasing the pins that held the door open, the door and the hydraulic cylinder fell, pinching their left hand between the hydraulic cylinder's base plate and the furnace. The employee suffered amputation of the little fingertip.

An employee was helping stack scrap wire. A fork truck was setting a carrier of scrap wire on top of another carrier. The scrap wire on the fork truck caught on the second carrier, and the carrier on the forks was pulled off. It struck the employee in the head, causing a concussion. The employee was hospitalized.

On July 7, 2025, at approximately 1:45 AM, an employee was moving vermiculite in a zinc pan with shovel. Molten zinc entered his left boot and caused burns to his shin and the top of his foot.

An employee was stringing wire around a drawing block at a wire machine. His left hand became caught between the wire and the drawing block, and he suffered an amputation to the ring fingertip.

On December 6, 2023, an employee's right hand was on the hinged side of a door jamb when the door closed, resulting in a partial amputation and a fracture to the right little fingertip.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.

An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.

A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.

An employee was changing a section of pipe on a sulfuric acid tank when the pipe broke and acid splashed onto the left side of the employee's body, resulting in chemical burns to their left shoulder, the back of his arm, and his leg.

On August 1, 2025, at approximately 5:05 AM, an employee was applying a label to a spool of product on a crane when the employee s arm became caught between two points of the crane. The employee was hospitalized with a degloving/avulsion injury to their right arm.

An employee was making an adjustment to a machine when his finger got caught in the machine. He sustained a partial amputation to the fifth finger on his left hand.

An employee was working on a wire drawing machine when three fingers on their right hand were caught between the rolls with the wire intact. The employee sustained an amputation to the middle and ring fingers and was hospitalized.

An employee was working at a threader machine. A spindle caught her sweatshirt. She was pulled into the machine, which pulled off her hooded sweatshirt and pulled in her hair. She suffered a scalping and was hospitalized.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.